ZOKLU2 Pcs Luggage Handle Replacement - Suitcase Handle Replacement Luggage Handle Suitcase Straps Suitcase Holder Replacement Handles for Bag Plastic Handle - 8.8" Luggage Replacement Handle Strap

Worked great. Was able to repair my suitcase with minimal cost. Minor hole adjustment was needed. But much better than a repair shop cost. Looks fine.

Handles were a perfect fit to our Samsonite luggage.Each fastener takes two Phillips head screws and washers that were provided. It would be helpful if one of the screws for each fastener (4 total) was a little longer than the other one since each fastener will accommodate one longer screw. I used the original longer ones to secure the new handles and fasteners.

I received only one handle with hardware for two handles (I should have received two handles). It was very poorly and unprofessionally packed in a Ziploc bag. The other hardware was wrapped in a paper towel. It appeared that I had received items that someone had returned. I returned the item to Amazon and requested a replacement. The second package was the same. One handle in a ziploc bag and hardware for two handles wrapped in a paper towel. It is a scam to rip people off their money. DO NOT buy it. Cheap quality and only one handle for the price of two.

This was a good buy. Unfortunately, my original suitcase handle was mounted with a shorter strap so I ended up drilling an extra hole on the suitcase for each side of the plastic retainer.After that it fit well and I'm going to test it out in a few days.The plastic retainer design is the same so it does not appear symmetrical.Other than that all fasteners were provided which was good because my original strap's fasteners did not fit.

The quality seams ok. I received the mounting hardware for 2 handles, but the package only had 1 handle.

Excelente calidad. Estan perfectas y muy fuertes. Recupere una maleta grande

The items are built very well. Though my initial purchase was to replace the main upright luggage handle on my large Victorinox 27inch soft case that had basically disintegrated after my last trip to Europe, Victorinox discontinued any replacement handles for this limited-edition piece. I needed an 8.5 inch handle and these handles are a bit longer and smaller width metal bracket, so with a metal file I was able to slightly ground down the mounting sides underneath where the screw goes to mount to the frame, and then used a power drill screw bit to make a curve center on this new handle so the handle would once again slide back inside the metal grommets holding the handle when not in use. After a few minutes of work, I had achieved a very good replacement handle and ready to use this luggage again.

I used this to replace deteriorated handles on TravelPro Crew 4 luggage. Dimensionally they were a near-perfect fit. The strap part was just a slightly different length but still a great fit. The screw locations on the brackets were in exactly the same location. The only issue was that the supplied screws were a little shorter than TravelPro’s, but luckily the threads were identical, so I just reused the TravelPro screws and everything worked perfectly.