Arctic Silver 3.5g High-Density Polysynthetic Silver Thermal Cooling Compound Paste (Arctic Silver With Tool)

Lower temperature for my gpu and cpu. This amount can be used over and over again for. Used it 5 times already and still got more juice for another 4 applications. Temp from 80°c to 65°c full load! Thats what a quality thermal paste does.

I've never over-clocked a CPU before, so had never used thermal paste before. I followed the instructions, which guided me through the best way to apply the thermal paste to my particular CPU in order to get the best possible heat transfer to my heat-sink. Everything went well and I now have a faster PC running at a stable temperature, so I'm very pleased. There is enough paste left to do this again and I'll be much more confident after my first go.

Used this product to replace the thermal paste on my Xbox One X's CPU underneath the cooling system after I had my Xbox shut down due to "ventilation errors" every 5 minutes, after removing the old factory paste and applying this, I have not had a single issue since.

Used on my dell laptop after stripping the cooling fan to clean the dust out. Easy to apply and after a couple of weeks I've had no problems, the laptop is running well with no overheating issues, running cooler than before the clean but can't say if it's down to cleaning or this paste. It covered 2 processors and I still have loads left, I could probably re do the same job 4 more times with the amount I have left

My mid range gaming laptop was always seeing the CPU sit around at 95+ to a max of 105c this was causing issues playing games on lowest settings. Used this paste thinking if i shave 2-5c off I'm happier, didnt think I would notice. CPU has now been running at a average of 66c during use with games set back to near max settings, no lags very impressed.

It's become fancy to use other types of paste, I always stick with this reliable and good quality through the years.

Unknown thermal efficiency - couldn't test temperatures, as laptop is dead now. Paste is really difficult to apply as its not smooth, but contain smudgy blobs. It is also really sticky. All that causes big waste of paste during application. You need to put 0.25g of paste, the same will stay on the tool. Regarding the price - I don't think I will buy it again.

Haven’t used the product in the end. But heard from recommendations that it’s good.