DaierTek 30A 250V KCD2 KCD4 Rocker Switch DPST 4 Pin Red Lighted 120V Rocker Toggle Switch ON Off Heavy Duty T125-3Pack

Worked perfectly to replace the switch on my 33 gallon Husky compressor. I wired so the light is always on - it works exactly as I'd hoped!

Used to replace broken switch on heat press that was purchased through facebook market place it was $20 usd and a these switches made the unit work just fine. Good quality switch and if they break the package comes with multiple ones.

accurate description, fast shipping

These 30A rocker switches are solid and dependable for heavy duty applications. I used them to replace older switches on some workshop equipment, and they’ve been working great. The red light indicator is bright and makes it easy to see when the power is on. Installation was straightforward with the snap-in design, and the fit was snug with no looseness. The switch feels sturdy when toggled and gives a satisfying click. My only minor issue is that the housing feels a bit stiff at first, but it loosens up after a few uses. Overall, a reliable and well built switch that handles high current loads without any trouble.

Works as it should

Used as a kettle switch in a popcorn machine. Direct replacement for the original at a much cheaper price

If you are looking for a rocker switch for either the Power or Heat setting on a Vivo Cotton Candy Machine Candy-V001 Model this is your part. You will need to file the holes in the candy machine slightly larger with a dremel or file.. Also getting the original switch out of the machine is a super pain. But now it works again and I have 3 switches for 1/3 the price VIVO wanted to charger me for one. Vivo is NO HELP when it comes to getting you a part unless you pay them $25 or have an original invoice.

It's a switch and it works. I can't evaluate the light part of the switch, because my use is strictly to make my portable generator switch between "BONDED-NEUTRAL to FRAME" and "NON-BONDED NEUTRAL". Which means, I am switching the AC neutral on my generator from being bonded to ground (like normal electricity in your house; so I can use it with extension cords and portable stuff); and NON-Bonded to ground to I can connect the generator to my house electrical panel (via a transfer switch); because NEC requirements don't allow the neutral and ground to be bonded in MORE than 1 location. (Preferably the main service panel). And being the main breaker box service panel is bonded neutral-ground, I have to remove the neutral-ground bond on the generator. Thus, I am basically switch a ground wire on and off, thus no voltage, thus the light on the switch doesn't light. I could make it light if I wanted to, but it's not important to me. What is important, is that I have a switch that can handle 30 amps so if there is a circuit problem when using the generator, the fault can make it back to the circuit breakers on the generator and make them pop. If the switch is too low of a current, like a 15 amp switch, a fault could burn up the switch and the electricity won't make it back to the circuit breaker to pop it. Thus, I could have hot electricity still on the faulty circuit, or worse yet start an electrical fire. So for me, this is a great product. 30 amps and does what I need it to do.