TEKPREM 1/4 Inch Magnetic Bit Driver, Screwdriver Handle for Holding Bits and Screws with Non-slip Material and Strong Magnet Tip, 190mm

Best of lower priced drivers I have found here. The socket fit is quite good, no wobble or slop in the bit when inserted. Seem quite durable under normal use, and has excellent balance when holding. Magnet strenght is adequate for any bit I have seen used. HIGHLY RECOMMENDED add-on to your toolbox.

Works great, magnet held bits very nicely yet they were easy to remove when done. The magnet was not strong enough though to pick up the screws when unscrewing them. Handle was a nice diameter so your hand could easily grab it and apply torque.

I wanted to keep a simple tool bag for inside the home. I already had a few 1/4" bits but wanted a driver for them. I have another driver, but the bits fit too loose, in my opinion. With this driver, the play is very minimal. The magnet also does a good job of holding onto the bits. I do like the rubber on the handle and it's comfy for a screwdriver. I debated which driver to get on here for a while. I'm happy with my purchase. I'd buy it again for sure.

This is a very nice combo screwdriver. I got the non-rachet version, and it's lightweight and easy to hold. It's a good selection of bits and they seem durable. The Torx 15 and 20 bits even have the hole in the end so they will work with tamper-proof fittings. I appreciate the square drive bits which are not included in some combos. I especially like the extending shaft. The wire detent locking mechanism is solid and easy to use, and does not rattle when snapped into place (a pet peeve of mine). There was a slight rattle in the handle due to the bit holder (that pet peeve again), which was solved by gluing a small piece of foam rubber in the cap. The end of the shaft is a ball detent style, so the shaft can be fully removed and used with a ball detent chuck. This is a very nice tool - and for the price, a great tool! Edit: Just discovered a great extra feature. You can remove the shaft and insert one of the bits directly into the built-in chuck to make a perfect "stubby" screwdriver. SEE PHOTO. The bit locks perfectly into the wire detent chuck.

This is great for ~ $7. Even though the magnetic force on this Bit Driver is not overwhelming, it does make your steel bits become magnets when you insert your bits, and your bits will pick up screws perfectly fine. The soft handle does work great for allowing you to apply more force to loosen or tighten up screws. The size and length were perfect to allow me to keep in in my existing toolbox which has clips to hold the tools. I use it and it works good.

Full size handle for hex bits. Don't know why these are unobtainium in stores. Bits fit good and are held in place reliably with the magnet.

I liked this item so much - I immediately bought another one for my garage tool set !!

Works with all my existing screwdriver bits!