Decopolitan Urn Telescoping Double Drapery Rod Set, 36-72", Bronze

Looking to elevate the aesthetic of your living space while maintaining functionality? Look no further than this beautifully crafted rod set. It offers a perfect blend of style and practicality, making it a must-have for any home decor enthusiast. First and foremost, the antique bronze finish exudes timeless elegance, adding a touch of sophistication to any room. Whether you're aiming for a classic, traditional look or a more contemporary vibe, this rod set seamlessly complements a variety of decor styles. But the real magic of this double drapery rod set lies in its functionality. With two rods, you have the freedom to layer curtains or drapes to achieve your desired level of light control, privacy, and style. Whether you prefer sheer panels for daytime elegance or blackout curtains for a restful night's sleep, this rod set accommodates your needs with ease. Installation is a breeze thanks to the included mounting hardware and easy-to-follow instructions. 10 out of 10 recommend...but hey Amazon...it's metal... how can it be sheer??

Would definitely buy this again! Relatively easy to put up with one person as I did, but would go faster with 2...esp to hold the level while marking the holes for the brackets. As others have stated, the holes are a little difficult to get to. The brackets seem sturdy even though they don't seem to be 100% straight... They are slightly twisted, but it doesn't interfere with anything and really isn't noticeable. I haven't 100% tested the light factor, but in the early afternoon with the lights off, it seemed to be doing a pretty darn good job! Here's some tips that might help those trying to decide whether these are good for blackout curtains and darkening rooms: 1) The way around the mounting holes clearance is to drill or use the screw to make a pilot hole... Depending on what material you're putting it into (I was installing them on paneling)... Put one screw in with a regular screwdriver until it's almost all the way in and then put the other screw in the same way. While it's loose, the bracket can lean to the side as you're screwing it in. Once the screws are almost in, hold the bracket back against the wall, and it will be easier to tighten the rest of the way. 2) a 4' bubble level and a small (even 2") bubble level help immensely. I used the four foot to level the brackets across and then I used a smaller level to level the bracket vertically. 3) I'm not sure how wide I made the rod altogether, but it worked out perfect because half of the rod sits in the two right brackets then the second half of the rod slides into the left. I think in the long run, this will make it sturdier versus it resting on the rod that slides inside, but I realize it's not possible with all situations. I also butted the end knobs up against the bracket and used the set screws to help hold them in place. Since I won't be opening and closing them a lot, I can't tell you how well it'll hold up to actually sliding the curtains across the bars without them moving, but I'm sure if you use a screwdriver to tighten the set screws instead of just finger tight, they will definitely hold the rod in place. 4) As you can see in the pictures, I have grommet room-darkening curtains. I overlapped the two curtains in the middle and took the last grommet, brought it out over the front rod and just hooked the Grommet over the knob on the back rod. That brings the curtain closer to the wall and will hopefully eliminate any side light. Overlapping the two curtains doesn't affect being able to open the curtains either...except sliding them open (obviously).They can still be pulled back far enough to let enough light and breeze in when needed. The last picture is to give you an idea on how close the curtain rods are to the window. A lot closer than I expected. The molding on my windows are an inch thick.

I needed to purchase a curtain rod for my bedroom window asap. I just started working graveyard and needed something classy but affordable. My windows in my bedroom are corner windows making it difficult to find the right fit. I also wanted to have the option of blackout or sheer curtains depending on when I want the sunlight. I ended up purchasing two of these & rod connectors (sold separately) and I must say it worked out pretty well. I love that they are double rods. My windows are only 42” to 52” and I felt that they were very sturdy. Not sure how it might work for a wider window with heavier curtains though. The rods come with 3 brackets (I bought 2 sets so 6 altogether). Super easy to install and they look nice. If you do plan on using them for a corner window like me I would suggest buying smaller connectors. I still made it work though. Definitely worth the price.

I would like to start by just saying these are pretty good for what you pay for them. Overall: they look nice, they're easy to install, and they're affordable. So I'm happy with them. Install: Installing these things is super easy. It comes with the hardware and instructions that are simple to follow. Tools you will need: - A standard Philips head screwdriver - Ability to read and follow instructions - Some common sense Nice to have: -power drill I read a lot of the reviews on this product prior to buying it, and some of the bad reviews are totally fair (like the lady who got brackets without holes in them), and some of them are just ridiculous (like the guy who's upset because he can't fit his drill under the bracket to reach the screws). If you read and follow the instructions you won't have any problems. Measure out and drill your holes first (if you don't have a drill borrow one from a friend or something). insert the screw anchors. line up your bracket to the anchors use a screwdriver (which fits perfectly fine under the bracket) to screw in the screws. put curtains on the rods insert rods into brackets screw on end caps Done. Don't be that guy that tries to power drill the screws into the brackets. That's dumb, and you clearly can't follow simple instructions if you do. One of the reviews had a tip for the brackets and i'll share that here too. If you swivel the bracket around and screw in the bottom screw first and then swivel it back up and screw in the top screw it makes it a tad easier. All in all it took me like 20 minutes to put up two sets of these things. Quality: The rods themselves feel like pretty much any standard curtain rod you would buy at walmart or target. You're not going to be able to hang from them like a monkey, but they'll hold your curtains just fine. I've got some heavier blackout curtains on mine and the rod is holding up just fine. My only complain is that the extension rod goes on the end of the smaller part of the main rod, so you have a skinny rod right in the middle, but once they're up and you have curtains on it, you can barely tell. The brackets are made out of a soft metal. it feels like aluminum, so they feel a little cheap, but for what you're paying they hold up really well. As long as you're not smashing them with a hammer or something you should be pretty happy with them. Overall: If you're not an idiot, and you don't freak out over little things, then these curtain rods are great. They hold up well and they look nice. Don't expect them to be amazing. you're not paying for amazing curtain rods, but they are pretty good. I like them, and more importantly, the wife likes them. If you can't follow simple instructions (I'm lookin at you power drill) then these curtain rods aren't for you.

I had ordered curtain rods from Amazon before but those by far my favorite. Easy to install, good looking, and well priced! Ill recommend it!

Great for the price. I used these to curtain a wall behind my bed. When you get them, take the rods completely apart and toss the plastic caps used for shipping. Sort by size, 3 smallest are for inside rod, 3 largest for outside rod. Reassemble each set with the two largest pieces on the outside ends and the smaller inside. DO NOT put the decorative caps on till the very last, but do make sure you have the correct ends on the outside. You will need to do this for both sizes of rods. When you install the brackets, undo the thumb-screws (that are used to secure the rods later) all the way out or the rods won't fit. This is VERY important if you are installing them by yourself, otherwise you'll be climbing down, moving the ladder and climbing back up a couple dozen more times than you plan to. After the brackets are up, you will have to put half your inside (sheers) on one end of the rod; insert that rod into the end bracket and center bracket (use the small center rod to reach the center bracket). With that resting on the brackets, put the other half of the sheers on the other rod piece. Now slide that rod over the smaller center section of rod resting in the center bracket, and back it into the remaining bracket. Now you can put the decorative ends on. Don't tighten the thumbscrew in the center till you have the ends lined up the way you want them (I didn't tighten mine at all). Now you can fluff the curtains to even the folds. Follow the same procedure for the top curtain (or valance or whatever you are using) This rod set is nice and sturdy. If you can't find the color you want for the end pieces, the rods and brackets are nearly black and you can easily spray-paint the endcaps (or not even use them for a sleek look.) My end caps seem to have a brassy tone, so I'll likely darken them next time I have the energy to haul that ladder through the house again. It took me a little less than an hour to install, but my small room has 10' ceilings and trying to work around the furniture that I couldn't move very far. Also plaster and lath is difficult to drill through, so it was hard to get high enough to get good leverage. I needed a LONG Phillips bit in my screw gun to clear the curve in the bracket. I actually didn't need the double rod, but it was a better price than the single and I like to change things on occasion so may need it in the future.

The quality is terrific, and the size is perfect. The product is exactly as pictured, and it works great, is easy to assemble, and offers an excellent value for the money.

Many other reviews complained about product durability, but the brackets and rods I received seem totally adequate to support the curtains I bought. Several reviewers noted that the design of the brackets was such that it was difficult to install the mounting screws due the shape/design of bracket that interfered with getting the screwdriver onto the screw. Based on some pictures attached to those reviews I, too, was worried, so I purchased a small offset ratchet screwdriver just in case. But it appears the manufacturer may have addressed this design issue, and I was able to install the brackets quite easily, and it was virtually a straight shot for the screwdriver to drive the screws. Another main complaint of reviewers was that for installations between 8 and 12 feet there was an unsightly section for both the larger and smaller rods where the inner rod was exposed, because the inner tube has a smaller diameter in order to telescope into the outer tubes. I can appreciate that complaint, but for me the finished width of my curtains was about 8 feet total, so the smaller diameter inner tube wasn't exposed at all, so there was no unsightly step down in diameter toward the middle of the rods. So for me that was a non-issue. The inner smaller diameter tube for each set of rods served only to join the two larger diameter tubes. The complete installation took about an hour, and the final result looks great. I'd buy these rods again for the same size curtains, but I'd probably think twice for curtains wider that 8 feet.