Step 1. Clean the door frame and waiting for few minutes until the cleaned areas dry completely. Step 2. Place the mesh flat on the floor with the sewn velcro facing up. Step 3. Attach the supplied velcro strips to the top and each side without removing the backing tape. Step 4. Peel off the backing tape from top velcro strip. Step 5. Stick the mesh to the top of door frame,make sure the mesh in the proper position,and the center of the mesh slightly higher than two sides.Peel off the white backing tape from two sides slowly and stick velcro to the frame from top to bottom.Make sure the mesh not pulled too tight across the middle for the magnets line up and closes easily, Step 6. Check the mesh if opens and closes correctly,make adjustment if necessary.Optionally:You can use push pins for extra support,wooden door frame only ,but will leave small holes in your door frame.
