2-Pack 8 Pin PCIe Cable for EVGA Power Supply, PCIe 8 Pin Male to (6+2) Male PCI Express Power Adapter Sleeved 25-inch (63cm)

I upgraded from a 3060 and needed an additional power cable to my new 5070. Even though I already had a cable on my GPU, I didn't want to mix cable types. It probably would have been fine, but if my original cable carried more voltage and the new one didn't - it could creat issues? I'm not sure - but I didn't want to risk it.I bought this two pack, installed in a snap, hooked up and the GPU has been running great. Fits my PSU and GPU, decent value for the cost, and compatible with my EVGA Supernova.

This works great but make sure you read these points before you pull the trigger!1. Firstly, My review is for this cable on EVGA power supply units ( PSUs)2. Please understand a bit more about this cable, especially about what type of Pins ( male or female etc)A) This is a "8 pin MALE to DUAL 8 pin MALE connector ( 8 pins on one end and 2 x (6+2) = 16 Pins on other end )"2) You can also use this as "8 pin MALE to DUAL 6 pin MALE (2 x 6 =12) or 8 pin Male to 14 pin ( 6 + 8 =14)" connector.3) 8 Pin Male side connects to Power supply AND other side Male sockets ( female sockets of Graphics card.4) having said this, my POWER SUPPLY UNIT is "EVGA supernova NEX 750 B1 (P/N: 110-B1-0750)" which is not listed as compatible in the product description here but THIS CONNECTOR WORKS !!!!Thank you!

Needed a new cable my GPU was not working well would not get enough power. These helped works fine now. Let's see for how long. Make sure to read if your psu matches with what this cable supports

So I purchased these and needed just one and plugged it in and it was working right out of the gate, no issues at all. Used to power my GPU. All of a sudden my screens went black and noticed the GPU was no longer powered up. So I tired the other cable (the one I didn't use the first time) and it started working again, then a few weeks later the same thing happen, now they are useless. Very poor quality.

Great Quality, fits perfectly, and works well.

I had to shave off 2mm to get the securing clip to fit into the smaller latch hole next the the PCIe socket on my Thermaltake PSU as the latch on the cable was too wide.

Worked perfectly

I used these 2 cables to install my RTX 3070 on my EVGA 850GQ power supply. Good quality cables and no issues so far.