HILDA Sanding and Grinding Guide Attachment Locator Positioner for Dremel

描述

Installation Instructions: Step 1: Remove the housing cap A from the end of the tool and set housing cap aside. The original housing cap must be reinstalled when this attachment is not used (Fig. 1). Step 2 & 3: Loosen the collet nut and place your accessory in and tighten. Note: The attachment is for ½” diameter accessories or smaller. When inserting a bit into your Dremel Rotary Tool be sure that the bit is securely inserted into the collet. Always use the wrench to tighen the collet nut to prevent the bit from loosening within the collet. Do not use the Dremel Chuck. Step 4: Thread the attachment B onto the threaded portion of the housing collar C (Fig. 2). Step 5: Adjust the attachment B to the desired depth by loosening the wing knob D (Fig. 3). Please note that Router bits are not allowed to use with the Sanding/GrindingGuide attachment.