MixRBBQ Digital Electric Smoker Stand for Masterbuilt, Smoker Legs with Wheels for Masterbuilt MB20101114 MB20071117 MB20070421 40 Inch & 30 Inch Universal Leg Extension Kit Accessories

directions were not good,

Easy to mount on the smoker

I have a Masterbuilt 30” digital smoker. When I first got out the parts and the directions, it was confusing. The instructions are small, not very detailed and hard to read. But one I got the other two screws that came from my smoker I was able to put it together fairly quickly. Some of the other reviews nearly had me returning it, but I was able to line it up to the holes and attach the side supports just fine. Once I tightened everything down it seemed pretty secure. Overall I’m glad I got them and that my smoker is off the ground.

Worked fine

I'm not really happy with this stand. Even though I got it to fit, it was a PITA to do so. The 4th cross beam was off by an inch and I had to get my innere Hulk on to fix it. Once installed the smoker tilts back a few degrees but that's ok since goo drains out the back. Go gravity go! It's not level though and there are no leveling feet or holes to install the factory one's you have to remove for installation. I will drill holes and install the leveling feet but that will make the unit tilt backwards even more so we shall see the outcome of my idea. I will post an update when I do. Overall I recommend going with the OEM stand not this aftermarket junk.

The only reason that I purchased this stand is that the one I bought about 7 or 8 years ago got bent up when the bungi cord that secured my original one to a fence post failed and the smoker with the stand attached "flew away". The smoker with the stand attached became bent up(destroyed) during the wind storm. This is for the replacement. I hope that it Iasts as long!

I should have believed the product reviews before I ordered it this leg kit. The pre-drilled bolt holes that attach the legs to the bottom of the smoker are not in the correct position to install the leg braces that come with the kit. In particular, the 18-inch braces were too long to fit across the back legs or to fit properly across the front legs (see photo). In order to jury-rig the kit for my 30-inch Masterbuilt smoker, I had to fasten the leg bolts through the oversize structural holes next to the bolt holes. This was accomplished by overlapping the bolt heads and washers on the edges of the oversize holes -- not proper construction technique. All in all, it was a royal pain to assemble and ultimately required a lot of additional time and creative engineering. This kit is very poorly designed for its intended application.

Did not fit my smoker.