ProTech Hard Shell Laptop Case Fits Dell XPS 13 Plus 9320 (Clamshell) Slim and Lightweight Reliable Scratch-Proof Clear Protective Cover for Office, Business and Commercial Use

As recommended by other reviews, check out the website of the producer for instructions how to put the case on. The case seems fairly resistant and accommodates the correct locations for the fans, openings and ports of the machine, which is a Dell XPS13 Plus. It sits very tight and an accidental detach seems unlikely. However, this is also deficit, since installing it could easily scratch or damage the system if not done very carefully (compared to adding a case to a phone for example). Even though the case closes, the laptop inside does not anymore. Overall for this price I would not buy it again. I could imagine less issues with a material more akin to rubber.

This case fits the Dell XPS 13 Plus 9320 just fine. The fit is not loose. The cutouts at the bottom align perfectly with the vents of the laptop. The cutouts corresponding to the USB-C/Thunderbolt ports are wide enough and do not interfere with plugging-in USB-C/Thunderbolt cables. The lid/screen of the laptop opens at the the full range of angle per the design of the laptop when the top case is installed. Installation: It takes a little bit of time to figure out which end of the top case and which end of the bottom case to install first in order to not scratch or damage the laptop. For both the top case and bottom case, install first at the front end of the laptop, then carefully work on the sides, and then work on the back end last. Once the top and bottom case are fully installed, the fit is snug and not loose. No issues opening and closing the lid of the laptop.

Case is slim, lightweight and does not add bulk to laptop. The case is cut exactly for this laptop; a super tight fit. You can't just pop the case on. You have to position the laptop onto each piece and carefully and slowly work each piece onto the laptop - go to manufacturer's website and read the instructions (with illustrations) first. Installation of bottom piece was easier than installation of top piece. Installation of top piece was a bit more difficult because I did not want to damage the screen, based on reading other reviewers' experiences. I could see how someone could easily damage the screen if not careful. You have to slide the case from the top and shimmy the case down the laptop screen. As you're shimmying the case, you have to make sure it shimmies down level across the width of the laptop. Otherwise, the case pops off. I slowly and carefully tapped the left side, then moved to right side, tap, tap tap, and back and forth and back and forth, keeping the case level as it was shimmied down the entire laptop. Then you have to pop in the corners gently. Wish manufacturer had a video.

See my video. Bought for the new 2024 xps 13 9350 lunar lake laptop. Same mechanical laptop as xps 13 plus.

They have a nice product but there is a sticker on the top of it that I have been working trying to remove for about an hour. I like the case so far but this residue is on the darn lid so I am gingerly trying to remove it while still attached.... too fearful to remove it due to the tight fit.