QL-110807AG

High quality waterproof enclosure. Has pegboard backplane for easy attachment of controls, relays, etc. Moved my indoor-rated sprinkler controller out of garage to side of house and needed to protect it. This waterproof case was an easy and cheap solution. Very pleased with the quality, includes stainless hardware, o-ring gasket and durable snap closures. Should last a long time.

Nice exterior project box that I used for a WiFi extender that needed protection. The clear cover uses proprietary screw lugs that you have to tap into place on the cover - see the short video. Once installed in the cover, they lock down tight. They supply on extra screw lug. Worked well for me, has many uses, would buy again.

Worked great. Appear to be water tight. Good quality materials.

GREAT!!!!! Using in my boat as a main electrical box with gauges and switches ...circuit breakers....etc.....heavy duty and very pleased with it!

The box I got had a few slight surface blemishes in the clear cover. Perhaps I can polish them out. But the time and date stamp molded into the cover was disappointing. I would have preferred that to be done on the back side of the bottom. The plastic was easy to drill and so far seems to be holding up just fine. Over all the box is fairly rigid for it's size. And since my project will be used strictly indoors, I'll remove the cover gasket to make it easier to latch closed. It did come with a hardware package to fasten the internal building plate. The plate was one of the nice features I like. I can assemble 99% of my project on that, then just install it in the box and I'm nearly done. I just wish the hole pattern in the building plate was either on 0.1 inch spacing or better yet nonexistent. If I buy another one with that building plate, I'll just replace it with a solid piece of G10 instead.

Item as described. Used for electronics setup

very strong material, the bread board mounting mesh fixed to the rear interior is perfect for mounting components. the rubber gasket seal also works great at keeping your hardware safe, would deff buy again!

The box is sturdy with good weatherproof seals. The raised platform makes it easy to mount items in the box without having to drill into the weatherproof box. When a hole is needed in the box, the plastic is soft enough that it does not crack when drilled with a hole saw. Stainless steel mounts make it easy to adapt to variability in the mounting surface. I mounted two 2-gang power boxes inside with a 6 circuit terminal bus. The top box has 2 light switches that control two duplex outlets below. This assembly is used to control the equipment for my pond. It is mounted outside with full weather exposure in south Florida.