NuMax SPS08 Pneumatic 0.8 mm Tip Mini HVLP Gravity Feed Spray Gun with 125 cc Plastic Cup

Incredible value. Anything I with will sound like I was paid to review this but I bought it on my own dime expecting a sprayer that would do the job, no more. Might be the best gun I have ever used. This thing is fantastic and costs no more than a couple rattle cans. Running it on my little 4 gallon compressor spraying primer on steel my compressor barely sweats. I've used big brand guns and this will hold up, you might get 5% better for 20x the price

Although it is cheap, it works well for small pieces.

Shipping was fine. But right out if the box, I could see that the finish around one side by the air cap is chipping away. It works perfect and everything else about it seems perfect. Maybe the finish just isn't so great. But that don't matter to me. Sprayed a coarse silver metallic base coat good.

Good little gun for the price . Doing what it needs to do so far

I used this spray gun once and now it leaks air. After troubleshooting found the oring in the handle was already worn. Flipped the oring/rubber washer that sealed the air leak. Only used this once as stated above should not wear out a rubber washer. Only had this unit for about 4-5 months. I have contacted the company hoping they sell or supply the small parts.

It took a while to finally get to this as the project I needed it for was coming together. The spray pattern is great. So far, the needle and cap do what you bought them to do with all the various settings you can apply. I played with air pressures from 15 all the way up due to the work I needed it to perform. There is a point of no return on each end of the spectrum just like any paint gun which will vary according to what you are asking it to do and the media you are using through it. Don't leave the gun in the cleaner solvent (synthetic enamel reducer) long as the finish will lift as mine did after just a few hours. I let mine soak between colors in the booth. Won't do that again. Also wash and immediately let the plastic cup dry, as it will deform and make sure the cap is just a little more tight than usual or it leaks during use. Hey, this isn't a $900 Iwata like my others, so it is what it is. Other than this it functioned quite well for my paint project which required multi layers of colors with pearls and fogging to get down right.

Came missing the adjustment knob on the back, I figured it’s an honest mistake and sent the company an email. They didn’t respond. Besides the obvious missing parts it came with seals that didn’t seal for the air line and in the spray nozzle the holes are off center. is a piece of junk don’t buy it.

fast shipping

Poor quality, fluid leaking through the air jets, no spray pattern.

It's a good little gun for rims and small jobs. Jobs smaller than a car

Leaks paint. Leaks air. Worked well for about ten minutes.

Comes with a nice regulator. Works well

I use this for spraying Minwax Polycrilic on furniture. It works flawlessly. The people complaining about things not coming apart for them must just have to try a bit harder? Everything comes apart easily for cleaning, and I am very happy with my purchase.