BBBOX Jeep Cherokee XJ Center Console Support Bracket Jeep Cherokee XJ 1997-2010

Console support was broken in XJ. Bought this and hoped it would be better quality. Hit the jackpot. This one is metal and solid. Had to tighten each screw little by little because the holes don’t line up all the way. Likely bc it doesn’t give like the plastic one. Once installed, it holds my console in place like never before. No wiggling or shifting at all. Highly recommend.

Fit great, easy install and fixed the wobble!

Fit great, though I had to use smaller screws for two of the holes, though I could've drilled them bigger if absolutely necessary. Center console's like a rock now (opened it up and the old one was in at least five pieces).

I picked one of these up for my 2001 XJ Cherokee since it looked well constructed and was about half the cost I've seen it elsewhere. A couple years ago I fabricated a similar bracket for my 2000 XJ from some scrap steel, but that took me a few hours to get it right and I figured at this cost I'd rather just buy one. I removed the seats and the console completely, not because you have to, but I wanted to clean the it up a bit better. This made the bracket really easy to get to. As expected, the plastic factory bracket came out in multiple pieces.Fit and finish is nice, I had to pull on it a bit to get it lined up, but all the holes lined up fine and the original screws went in.My only complaint is that the posts on the top are a very tight on the heater vent tube and make it sit about 1/2 inch further back in the vehicle so it doesn't snap in at the front connection. I added a bit of thin weatherstripping and some gaffer's tape to hold it together at the front connection and I think it will work fine. Put everything together and now the center console is super solid!

This is a great product. Replaces the plastic factory POS and fortifies the console to feel solid and new again. Excellent fit.

Terrible fitment, the bottom 3 bracket bolts wouldn’t fit you could only get 2 in and the third was way off. The 2 bolts that go through the center console barely fit but I had to grind down the sides to get it to allow the rear ac vent tube to fit. Otherwise built with great quality and my center console is rock solid. But the fitment was nowhere near stock

Fit was good

So, like most, by stock plastic bracket was broken and no longer served any actual purpose. I was pulling the interior to a 5 speed conversion and install of some sound deadened so I figured it was the perfect time to correct this. The price of this bracket isn't great, but its not outrageous either. Thought about fabing up my own, but for under $50, I thought why bother. I did have to use some force to get the mounting holes to line up on the body, but in my case I also had butyl underneath it, so I chalked it up to that. Was able to mount it though with little effort. The rear lower vent tubing is a tight fit in this bracket and sits a little further rear than with the stock bracket, but it still slips over the supply vent, just not all the way up. If I really care, I will grab some hvac tape to ensure the connection does not leak air. I guess I could also easily modify the vent tube to it doesn't hit the bracket and allows it to fully seat up front. But either way I was able to install the vent and center console now it is solid. no more shifting around or rattling. To me it was well worth it.