⚙️ Master BMW Timing Like a Pro – Never Miss a Beat!
The Vanos Valve Camshaft Engine Alignment Locking Timing Tool by FreeTec is a precision-engineered device designed for accurate camshaft positioning across a broad spectrum of BMW engines, from M42 to M73 series. Lightweight and compact, it streamlines engine maintenance by combining alignment, locking, and turning functions, making it an essential tool for professional mechanics and BMW enthusiasts aiming for flawless timing and peak engine performance.
| Manufacturer | freebirdtrading |
| Brand | FreeTec |
| Item Weight | 5.98 pounds |
| Product Dimensions | 0.98 x 0.98 x 0.98 inches |
| Country of Origin | China |
| Manufacturer Part Number | FT6105 |
K**M
Made it super easy to rebuild my Vanos on my E36 M3
I had the rattle and lack of power on my M3 for YEARS. Finally got around to doing the rebuild and these tools are absolutely KEY to make this successful. The only thing different with my setup was that I replaced my clutch/flywheel years ago with aftermarkets (which do not have a hole for the pin), so I didn't use the pin. Honestly, the cam locks are all you need to hold the engine still (unless you are changing the timing chain). I don't see myself ever needing this toolkit again, but for the price compared to other specialized sites, it was a no-brainer. For those doing this job, make sure you pay special attention to reassembly, there's a special sequence to preset/preload the Vanos unit before you push it back onto the cams!
G**N
Worked Great Slight Editing Not Difficult
Everything worked great other than the TDC pin.I just took the tdc pin stuck it into a drill grabbed a file and grinded it down until it fit wasn’t difficult good luck! ( tip of tdc pin fits fine it’s the main shaft of the pin that needs filing)
G**A
worked with modifications
The tool that spins the gear to release the vanos isn't properly made. I thought i was all set to got, had my cams locked and the pin is too fat to actually catch on the gear, luckily I was able to grind it down and make it fit, but not convenient when you're in the middle of a job to figure that part out.
J**N
Pretty good for the price
Used it and it worked great. Time will tell how long it’ll last but it looks pretty sturdy.
B**Y
Very Thick Steel looks like anyother more expensive kit.
Fly wheel Pin , Cam gear and Cam Shaft Locking tools included.
S**F
Cam gear tool needed modifying
Product looks to be of good quality but on the cam tool, I found the distance between the pin and the ring that fits inside of the gear was too tight. (It measured as 4.5 mm and it needed to be over 5 mm.) I was able to use a dremel to take a little off of the pin to get it to work.I wasn’t able to use the flywheel lock pin due to crud and corrosion on my motor.That’s the bad.The good.The cam locks worked great.Packed in a nice blow mold case and foam padding.To make removing the flywheel lock pin easier, I ran a cable tie thru the hole in it. Worked great while trying to withdraw it from the block.
D**A
it worked
had to file the part to fit the cam easier, was a really really tight fit and the lock rod needed a taper ground at the end to clear a boss in the block but what the hell you want for the price?!?!?!?
A**.
Fantastic!
Wouldn't have been able to perform the job without this kit.
Trustpilot
2 months ago
3 weeks ago
