TOURBONHunting Shooting Grind to Fit Recoil Pad (Pack of 2 Pieces)

These aren't the best but they are very decent,easy to cut down to fit I use a grinding wheel on a bench grinder then spray with wd40 and polish/sand with fine grit sandpaper,I use these to change the lenght of pull to add a inch and they work perfect for my need

I have used four of these with good results. I glued them to a hardwood base plate and then screwed them on to the stock. They work well for me.

Installation hack: A buffer or denim pad on a bench grinder will take down the recoil pad rubber but not the wood on the stock. Just takes a little longer. I made some nicks in the stock. When I went to buff out the spot finish I noticed the buffer wheel slowly removed the rubber from the recoil pad. It was super easy to true up the lines. No lip or overhang. Very smooth transition.

They only come in one size. They are not long enough or wide enough.

Great looking product with minimum fitting.

Tried attaching with screws, they pulled right thru, got to looking at them and decided they looked and worked better in the trash.

Nice enough pad but when it doesn't come with screws it poses a problem.The butt pad I am replace is very thin and the screws are too short to be reused.Should come with some screws that are lo ger enough for the pad.

Great recoil reduction, you will have to glue them on or do as I did and epoxy a backer plate on to be able to screw them on.

They were good and came fast.

Hard to size but ok when done

Added these to both carbines for recoil comfort. Perfect fit

Did not fit as expected. Disappomting

Not worth the work to drill and bore hole. Too rigid for the look.