Dorman 800-074 10 Feet Of 5/16 In. Nylon Fuel Line Universal Fit

Worked perfect. No leaks or problems.

I used this fuel line along with the 800-091 fitting and the Dorman 800-301 to repair my OE fuel line after it started to leak. It worked great and has been holding up perfectly.

I had to watch videos on how to install the fittings. They all reccomend heating the tubing, but this just would not work for me. I ended up tapping them in cold with block of wood and hammer. No leaks after installation.

Used this and some fuel fittings to replace a broken line on a 1996 Jeep Grand Cherokee. The tube is seemingly undersized and difficult to push on without the expensive kit. I ended up using a brake flaring clamp to hold the fuel line and my drill press to push the fitting straight into the fuel line. With this method it slipped on without the need for heating and since it was being pushed straight the fuel line did not get bent or creased.

This hose was fabricated to last a life time professionally fabricated and made for a perfect easy install with a feeling of security with no defaults. A great made product a great name to back it up . In my opinion it looks and works bettter then oem equipment. and was sent with a cense of urgency that alone speaks volume great job to all involved thanks again

It happened that I needed the full 10 feet, and got shorted. If it is critical that you get the full 10 feet, look somewhere else.

This is perfect for a 2002 Saturn L100 fuel tank return from the fuel injector to the pump (fuel FEED to the injector requires the larger 3/8 hose and quick-connect). Also purchase Dorman's 5/16 quick connects, plus 3/8 quick-connects and nylon hose for the feed port on the pump.Bend the nylon fuel hose with a heat gun, put a spark-plug sized wire inside the hose to prevent kinking, and heat the hose just enough to bend it to the correct shape of the original hose. Heat the end and use a vice, a brake-line flaring tool & c-clamp to push the adapter into the hose.

It would be helpful if it had some instructions about the install procedure, however i discovered a hack - mount the barb in a drill, use some wd40 and spin it, friction will create enough heat exactly there you need it to slide in. Practice your speed first, it worked best for me if i varied the speed a little bit abd not stopped until it was fully seated in. For a smaller diamerer barb head i iust used some grip tape and a 1/2 square socket adapter

all good

Perfect for replacing fuel lines that go up and over fuel tank on 2000 Accord v6.

Very good for diyer

Exelent produit

The Item in terms of quality is as what I expected, the only problem is that it is NOT 10 ft (120inches) long. It measured 117 inches long, so 3 inches too short, Which almost put me into a pickle, it was just long enough for my vehicle repair. In general I have found that Amazon is not quite up to snuff with car parts, which makes it really not a reliable source for parts, as so much is hinged on getting your daily driver back on the road. It is absolutely unacceptable to send out parts that are not as described or have items missing (like my recent fuel filter purchase from AMZ, which came without Sealing washers). In this regard It would be fair if I get some money back (including taxes) for the 3 inches missing, an apology would also be appreciated.