Wolf ToothSet of 5 Chainring Bolts+Nuts for Single-Ring (1X) Drivetrains

What can i say they're wolf teeth! Look no further !!! They're decent bolts, not el cheapos. Hooked up my sugino rd2s! The blue is very well anodised and matches my collar and headset. The paint did not chip or scratch when I tightened them down. Installation was easy, swipe a little anti sieze lube on the threads and tighten em down! Carful they don't require a lot of brute force to get the correct torque. These bolts have a clean profile!!! I love the double sided versatility. You're definitely getting what your paying for! Be sure to stock up on these for all your rides !!!

This set of chainring bolts use allen wrench on both sides to loosen/tighten, so it is very convenient and easy to install and remove. I am upgrading my '92 Cannondale 7x3 transmission to a 11x1 system. On the original Shimano Deore LX 3-piece crank, I removed the three chain rings and replaced them with a single Wolf Tool Drop Stop 36T chain ring. The installation using the Wolf Tooth bolts took very little time comparing to removing the original bolts and rings. Make sure you grease the bolt threads and tighten them to spec.

Well engineered product. Nice, deep hex sockets on both sides means you’ll never damage the nuts or bolts. Torque specifications given. Much better than stock bolts that require two specialty tools to tighten or loosen.

I've had to torque these a few times after 60+ miles. Haven't had a problem since but keep an eye and allen wrench on hand.

I purchased these RED chainring bolts to attach my Gates Sprocket to my single speed. I purchased RED because we all know it's the fastest color, and Wolf Tooth because well they make nice stuff. I was not expecting the extra watts these things seem to provide.On top of that they look good on the Hodala.

These are too long for use with a single chain ring. Because they are aluminum the threads are easily damaged

so far they seem great, I've still have to subject them to some more serious trail riding and I'll update the review if needed. I love the fact that they use two different hex heads, making it easy to tighten them up. don't forget to use some threadloker though. and did I mentioned they look good ?

I switched from a 2x11 to 1x11 drivetrain and needed shorter bolts for the chainring. These worked just fine. Be aware that they are alloy, so be careful your tools fit properly and don't slip or you'll mar the surface.

Well design bolt & nut for Wolftooth Chainring. Nicely finish and work perfectly. Just need 4 & 6mm hex to install.