Replacement Fireplace Fan Blower and Heating Element for Twinstar Electric Fireplace, Wood Burning Stove, Blower with Heather Element for Twin Star 28E05, 28E05R, TS-001, 23EF010GAA Electric Fireplace

Worked great. Had to change a couple things but did great and now our fireplace works

Direct fit and replacement.

Instructions not clear, but if you know a little about electricity, easy to hook up

Very good heater element. It puts out lots of heat and was easy to install.

Unsure exactly what is going on but my old blower motor says it’s TS-001. And this brand states its a replacement. Does not have the proper connections so if you know about electricity, and have the connectors, it can be done. However it is not as warm as my old one. It does work. But not as efficient . As reading other reviews it did mount but no threaded holes. If you are careful holding it you can use the screws to create threads. Either way, not satisfied with the outcome. I do not recommend.

So happy this fit perfectly in our RV. It was easy to install, very quiet and was and priced competitively.

Not a direct fit. Modification had to be made for mounting and changes made to the wiring. With all that it works ok

My electric fireplace heater stoped working so I did some research and decided this looked to be the exact same thing so I took a chance and I’m glad I did! It does take a little know how with shrink tube wiring connectors and following the lines to figure out which line goes to what part. It wasn’t completely obvious at first and it took me a little bit to figure out where to put each wire but you just have to follow the lines and take one line off of the old unit and then put that one on the new unit in the same place you took it off of the old unit and you should be okay. Just do one at a time and it makes it a little easier to understand which wire goes to what. My particular heater model did not require the one black line to be used so I just taped it off. I cut the wire ends off and added the correct spade end on so it could just plug into the heater unit. You can see in the last photo I shared how the red spade connector with black electrical tape is new, that’s the spade connecto. I had to cut the wire off of the old unit to remove it and I added the spade connector so it would plug right in. I also had to re use the black bottom mounting plate but everything mounted up the exact same and the same screws worked and I didn’t have to make new holes or anything like some other reviews mentioned. Everything lines up perfectly on my unit. So far we have used the heater aprox 40 hours and it seems like it works even better than it did when I first got the unit!

Set on fire want refund tht could set my house alight

Modifications were needed, It was for a sunbeam fireplace (2005). I had to tap treads on the blower casing and make new hole on my existing bracket to make it fit. The heater connection on top was smaller making the wiring to short to connect. I had to used my old heater that fit in the new blower assembly. I needed screws, Tap& Die set, zip ties, wire stripper, screwdriver and Sta-kons connectors to complete the install. I had the resources to do all that so the install is not for everyone. The blower cage is about 3/4 inch shorter than the OEM but the speeds seems similar. The fan does not wobble at all.

Stopped working after 3 weeks. I don't recommend.

It was delivered fast and works great.