Deep Pour Epoxy Resin Liquid Glass 0.75 Gallon Kit, 2-4 inch Super Clear Flow Casting Resin Kit, High Temp Heat UV Resistant, Bubble Free Food Grade Safe Low Viscosity Cast + Resin Pigment Pack

Exceptional quality. A deep, clear finish was obtained.

This epoxy is amazing. If you follow the instructions properly and take your time the results will be great. These were my first epoxy river tables and I had zero issues. I can only see complaints in reviews coming from those not following instructions. The room temp when I used it was 68-70 degrees F which meant about a 48 hour cure rate and then I waited another day before routing. No issues at all. Finally customer service. Superb. If you need help they will spend as much time as you need on the phone to get comfortable. Get some table top epoxy as well to do the edges before you start.

This is the only epoxy I have used, and I have no reason to switch. The cure time is a good in between, not too fast, so I can work with it as much as needed, but it dries quick enough that I can pour multiple layers in only a day or 2. I have found it to be the best value for the money. A few other pieces I've poured using this same resin have held up and not yellowed in over 2 years. Any bubbles are minimal and small.

Take your time when working with any epoxy. Many beginners don’t mix the epoxy long enough, don’t prep the working surface correctly, work in unfavorable temperatures, and/or don’t let the epoxy cure long enough. Follow the instructions, take your time, and the end result will knock your socks off!

I have poured this product as deep as 4" but I do not recomend it if you have little or no experience with sanding and polishing epoxy. Also if you do not have 3 days for a compleate cure before demolding the bigest problem with most deep pours are micro bubbles. With an epoxy and wood finish the small bubbles will be seen as specks in your finished product. If you die your epoxy dark as I do it will show every blimish / bubble as a lighter or dark spot on your finished product. You can go back and fill them with CA glue or mix a tiny bit of epoxy and color it but if the spot is not color matched exactly the same it may be visible on you finished product! The key is to take your time and get as many bubbles removed from the epoxy before pouring as possiable. You can do that by warming your epoxy before mixing to decrease viscosity and using a vacuum chamber to help relase the bubbles. THAT BEING SAID THIS IS HANDS DOWN THE BEST EPOXY I HAVE USED FOR DEEP POURS!

Perfect!!!! This stuff is really great. While it’s expensive it’s worth every penny. I did a ton of research before picking this resin and as long as you follow the directions your results will be perfect. I think the biggest reason some people don’t get a good result is they don’t follow the temperature guidelines! So I bought one of those room thermometers to make sure we were in the correct zone. This stuff is CRYSTAL CLEAR! Since this was our first time doing this we made some mistakes with our seal so it was honestly too clear for us and showed our mistakes at the bottom edge so we solved this by slightly sanding the resin to give it a “sea glass” finish. The propane torch removed all bubbles from this. We used the tips and tricks included in the instructions to get the best result. Be sure to read all the way through before starting.

Great working time...easy to use. Very low VOC and no funky smells. I am a repeat purchaser and will continue to use this product again and again.

Easy to work with and very good instruction for use.