Mica High Temperature Wire -60~450 Degree C,Strands of Nickel Plated Copper Wire,Insulation by Mica and Fiberglass,Used in Harsh environments (AWG18 10Ft)

Good product

Very insulated from heat, just make sure your picking the right gauge wire, being in est resistant doesn't help if it's too much current through the wire. When in doubt go a size thicker ( which is a lower gauge number. 10 is thicker than 16) this stuff works great though. Anywhere you need your wire to survive a hot environment.

Used for thermal switch for wood stove. Haven't had an issue, even after 3yrs. Very impressed!

This is high quality wire. I bought it for an Electric Dryer repair, which I know is probably not what this wire should be used for, but my electrician friend recommended it. When it came time to mark the wire with a sharpie for hot/neutral/ground it wouldn't hold a sharpie mark. Our hands ended up pink from the red sharpie we used for the hot. Then when we would strip it, we got fiberglass everywhere, which was a minor annoyance. The worst part was trying to singe the fabric so it wasn't around the actual wire when we made the connection. Obviously, since this wire is high-temp rated that was a chore. I give it four stars because I'm pretty sure I misused what this wire was meant for, and probably didn't know of the proper way to strip it. However, the fact that it doesn't hold a mark for hot (which is code in my state), is a ding against it.

Really good quality on this wire don't hesitate to buy it.

Quality wire been working great for a few months now

Cut and bagged by hand. Worked great!

I used it on a outdoor wood furnace that likes to overheat, so last week it overheated again and I went out to check why the blower wasn't acting right and found my snap disks had melted again ,normally when this happens the wire melts too and I have to spend a hour rewiring the blower control but not this time the wire worked great I am so happy with it