RAXIAL S6, Inline Booster Duct Fan 6” with Speed Controller - Low Noise Inline HVAC Blower Can Fan for Basements, Bathrooms, Kitchens, Workshops

Have this hooked up to the far end vent for a Bambu P2S printer to exhaust toxic fumes. Yes the instructions say don't use this for toxic fumes but I figured if thousands of others have been using this for their printers over the years it must be ok. There aren't a ton of toxic fumes, and they're not flammable fumes either. I would not use this for flammable fumes. It moves a decent amount of air once it gets to the midway power setting. On max it move a little more but this doesn't need to be hair-dryer speed to do it's intended job. Yes it's a little noisy if you don't have any vent tubes hooked up to it. I have it midway on power and connected to a flexible 4" dryer duct on one side and a tin dryer duct on the other. I can hear it from 5 feet away but barely. If you've ever been next to a RADON fan it kind of sounds like that...super muffled. It's right below our master closet and if I stand in the closet and purposefully listen, with no other noises going on, I can barely hear it but I know what I'm listening for. The spousal unit has not noticed at all, and she's in there a lot. I think that's her safe space, not that she needs one mind you. But with the clothes everywhere it helps to shut out distractions and noise and I see how it can be calming to hang out in there. Back to the topic--Once you turn it on it seems to start at 100% power, then quickly lowers power to wherever you have it set. Nothing wrong with that, just wanted to point it out. I have it plugged into a smart receptacle, so I can turn it on from afar. Should come in handy if I forget to turn it on and start a print and leave the house. Can also monitor energy usage, but I don't think it draws much. The housing is exactly 4" diameter, the exact same as most hard/tin 4" ducts. This is a little annoying. I have it connected directly to an outdoor dryer vent, and the tube that came with that vent is the exact same size as the housing, so I had to buy a short super thin adapter and clamp the vent to the adapter, then the fan to the adapter. I did get a 4" flexible dryer duct attached to the other side, little challenging but it fit. I only use about 4ft of the flexible duct, then it goes to hard duct and runs across the room to the printer.

This review is for AC Infinity RAXIAL S8, Inline Booster Duct Fan 8” with Speed Controller - Low Noise Inline HVAC Blower Can Fan for Basements, Bathrooms, Kitchens, Workshops. The fan was delivered on-time, complete, and as described by the seller. It was well-packaged in a custom box and included a user manual, 2-year warranty information, and hardware for mounting the speed controller. The cylindrical structure is sturdy and nicely finished, the plug-in power cable and speed controller are integrated and the fan runs smoothly with little vibration. The speed is continuously variable with a dial control from OFF to maximum; at highest speed it makes about as much noise as a pedestal fan….. the sound is principally from the airflow itself. The fan has steel blades and is designed to be mounted/suspended inline in an 8-inch diameter ductwork; there are no mounting brackets provided. I am using this fan, funning at medium speed, to increase ventilation in my attic with the expectation of improving the efficiency of my A/C system (also installing a reflective radiant barrier throughout); so far I am satisfied with the performance. I am using an Amazon Smart Plug with the Alexa application to run the fan on a regular routine and/or use voice commands to turn on and off remotely as needed.

I got the 6 inch one and have had no problem the dial actually smoothly adjust the speed it is a little noisy and makes a hum that you wouldn't want in your bedroom but besides that it works quite nice

I did a great deal of looking around the internet for user feedback on this fan. What I found was not stellar. However, nobody was steller that had significant feedback. The cheaper units had worse ratings. So, I went with this unit and paid a little extra. I'm quite pleased with this unit after receiving and getting first hand experience. I will list below what I found. 1. Built well and not flimsy. Not a peice of junk! 2. Not excessive fan noise like some of the reviews. The fan noise was not a problem at all. The house HVAC is louder than this fan on full setting. 3. Did not measure the CFM. However, output was more than the replaced fan while being quieter. 4. I cut off the speed control and operated it at the full CFM @120VAC. The speed control worked just fine. But, I didn't need that.

Good, solid construction. Moves a lot of air. The fan itself is no joke, so if you use it to vent a grow tent like I so you may want to cover the outlet with mesh. My only (minor) gripe is that there are only three available speeds instead of a potentiometer you can dial in more precisely.

Sturdy yet not as much air flow as expected, and bit louder too.

This is a long term review. I purchased this in 2020 and it's been running pretty much non stop since. That's 5-6 years!!! I like the metal construction, perfect for an exhaust for my 4x4 tent and 3x3 tent at the same time keeping temps nice and cool. Relatively lightweight and the perfect size for the standard grow tent. Easy install, just turn on. My only "gripe" would be the adjustable speed dial. I can really only get two fan speeds out of it. it's full blast, medium or off. No matter how much I fiddle with the knob. 6 years and going strong. I'd absolutely order this again. Although I'm hopeful it keeps working for another 6 years.

Pretty great fan, it's really not loud, I tried a lot of them, and this is very quiet, almost not hearable at the lowest speed

The product was exactly what the ad presented, size, colour, easy to install, etc. Installed it a couple days ago, was great! Quiet, speed adjustment....and today it just quit. Not sure if it iver heated or what...no burned wires or smell...nothing...just stopped working! I will be returning it and expecting a complete refund! Disappointed! **UPDATE ** After contacting AC Infinity, who were super friendly and helpful saying tgey would ship me out a new fan but have a quality check before they sent it out. I thanked them for offering but I decided to go a different direction for what I had originally purchased the fan for. Long story short...I shipped the fan back to Amazon and received my refund in just over a week. I most likely will give the AC Infinity fan another go in the future!!😊

Plugged in, switched on, 3 seconds and smoke comes out from the fan. Completely dead, so far had to pay £30 to ship it back, waste of money and time, bad experience. Got a German's made, works great. Germany-USA 1-0

Exelente producto me dejo impresionado su funcionamiento y estética ampliamente recomendado

Great fan only issue is that it came with a US plug. I needed it to have a UK plug. So I had to buy and extra 240v to 110v converter at £25. But it’s a great fan. Using it to power my home made humidifier on my mushroom farm. If it was adapted for the uk I would buy more.

het toestel heeft GEEN 230 volt wat ik verwacht wanneer je in Belgie op de amazon.com.be koopt en door belgische dealer wordt geleverd. klein foutje .... retour is direct aanvaard: wacht op de terugbetaling ....