winchance Halloween Decorations Life Size Skeleton Skeleton Skull Decor Graveyard Outdoor Halloween Home Decor Gift

No complaints. Looks good, takes paint very well. I personally like that the jaw is a separate piece, so if you decide to display it without the jaw you don't have to fight with it - it's easy enough to just glue the jaw in place if that's your preference.I wouldn't throw it hard at a brick wall, but the durability is fine and its solid enough for whatever reasonable purpose you might have.It's resin, so if you're going to be sanding it or cutting into it with a rotary tool, wear a respirator. I also wouldn't try to turn this into a drinking vessel for the same reason - resin isn't food safe.Considering you'll pay the same money for a flimsier, less accurate skull at someplace like Spirit Halloween, I don't think you can go wrong with this one.

Used this for an aquarium. Waaayyy cheaper than anything else around and looks awesome!

Well the plus side is that this Skull was much better quality then I anticipated, the only down side for me was that I wanted it to hollow out and install a magic eight ball.......This was a lot more difficult since the skull is such good quality and resin.

The look is amazing but the size is disappointing

The best prop skull I could have ever found! It is a light enough weight and sits well on its bottom. The only concern that would be needed is that the jaw is separate from the skull itself, but can be easily glued to stay in place.

I bought this skull.as a display for a stand I use as a forensic artist. I neglected to note that the mandible has been sawed short, probably to lie flat in a display. The skull itself is ok, but the shortened height on the mandible was a nuisance. I had to use some steel epoxy to finish the underside of the mandible so the skull would have complete and accurate proportions. The skull is brittle but sturdy if you are careful. I also noted that the lower jaw is a bit undershot in relation to the upper jaw, causing the teeth to line up top to bottom, but for decorations this would not be an issue. I would recommend, if you are using this for decoration, that you epoxy the top part of the skull to the mandible so the two parts will not be constantly sliding around relative to each other.

This is so fun. And I've always gotten lots of complements about it. It's exactly as described. 10/10 would buy again

Great quality and anatomically correct