Betterley Tru-Cut Blade Insert System. Fits Jet Right Tilt 10 inch Cabinet Saw (Xacta), Contactor Saw, General 50-250 and General 50-175

Description

Manufactured in the USA to the highest standards. These quality zero-clearance inserts are machined from ½" thick solid billet aluminum for a lifetime of use and engineered for the best possible performance and safety. Table saw surfaces are machined flat, the TRU-CUT Insert extends that accuracy closer to the blade with a machined aluminum body that is impervious to climatic changes unlike most factory supplied, plastic, or shop made inserts. The two-stage leveling system insures unparalleled accuracy while spring-loaded plungers are incorporated to eliminate vibration, movement, and provide simple use. Bottom side relief cuts for arbor and splitter allow saw blades to make full depth cuts at any angle. True zero-clearance reduces chipping and splintering along cut with full support of small or narrow work piece to prevent twisting, tilting or vertical movement that can cause kickback, insert is pre-machined to accept factory guard/splitter for safety. Red anodized surface will not wear off easily like paint and immediately draws attention to the "danger zone" near the blade. Durable phenolic Kerf Inserts are easily replaced allowing insert to be used with any 10" saw blade, or dado blades up to 13/16" wide for 90º cuts. Insert is supplied with one phenolic Kerf Insert with pre-machined starter groove for initial cut, additional inserts sold separately.