MagswitchDual-Roller Guide, Yellow

A must for any band saw out there.

Prefer this over featherboard for re-sawing on a bandsaw.Wedges included to adjust a perfect square, but instructions lacking I think.Wing bolts supplied need a re-design within the wedge to allow bi-direction adjustment.Brackets supplied to allow use with starter kit. Stack kit not needed.Would like to see a fully integrated (stand alone) Magswitch version with micro square adjustment.Probably only usable on perfect DAR stock, as irregularities would cause issues.

Superb product, so easy to use, can't believe how strong the magnets are and how well they hold. Has certainly made a difference to the machining I do.

Only thing I can complain about, is that the bearings have spacers that will limit the guiding contact this was meant to provide to the wood you're cutting.So, I removed the bearings, saw that they were marked as "608-RS" and did a Bing search for them. Purchased 16 on eBay from (usabearingsbelts) for $11.47.Only needed 14 to make the stacks all bearings, with no spacers and now it does an even better job of holding the material to be cut, snugly against the fence. I love this thing and would recommend it to my friends.

Attaches to the Magswitch baseplate (which you must purchase separately), creating a vertical roller-guide for resawing in conjunction with the bandsaw fence. Note, will only work with saws that have a steel or cast-iron table - aluminum won't work! Very solidly-built (if a little pricey). Nice add-on for your bandsaw.