JeCar Side Fender Vent American Flag Vinyl Decals Precut USA Flag Stickers Compatible with Jeep Wrangler 2018-2025 JL JLU & 2020-2025 Gladiator JT, 1 Pair

Looks great even though I've never installed vinyl decal on a car before.These arrive rolled up and one defiantly needs to get these close to flat before attempting to apply them. I pressed them flat with some heavy books for a day and then did a "reverse roll" using the supplied rubber bands to get the rest of the curl out.Because this was my first try I did the passenger side first so that any goofs would be on the side I rarely see and glad I did because it ended up very slightly canted. I did trim it some before applying it, but not enough to be able to accurately place it or fix afterwards. For the driver side I trimmed it closer to the decal and was able to get accurate placement. I used an exacto knife and cutting mat but my knife was dull and no sharp blades on hand and had a miserable time cutting without tearing so that's a lesson learned.We happen to have a vinyl cutter so I used the weeding tool or pick that came with it to help separate the backing paper from the transfer paper and decal as there is some stickage.Other than all that I followed the directions and they turned out great.

My advice is to trim as much excess paper from around the decal as possible without damaging the decal obviously. It doesn’t have to be laid flat, once you remove the decal and transfer paper from the backing paper it’s completely pliable. TAKE YOUR TIME!

As a previous vinyl sign printer the material used is cheap and the backing is way too heavy/sticky for the cheap material. I was able to get it on the jeep with lots of patience but not confident it will last.

Arrived as described rolled up. I let them set under a book for a few days. The day of install I clean the application area with a lint free sponge and peeled backing paper. Aligned sticker as appropriate then squeegeed the air bubbles out. Next I removed the cover paper slowly ensure no peel back. Squeezed out all remaining bubbles and done

As the other reviews have stated they arrived rolled up which a quick opposite roll and trim they were ready to put on. Take your time peeling them off the white paper as the transfer paper isn't the greatest. These are a wet apply so a couple drops of soap in the bottle provided wetted the area down after cleaning with rubbing alcohol. I positioned them in the vent area a little to hide the lines some and think they turned out great. After letting them set for 30 min after squiging them I pulled the transfer tape slowly with no issues. Then heat gun to help form a little around the curves (slow and not a lot of heat). All in all pleased with how they turned out just Remer to take your time with the install.

The decals I received had no instructions so I read several reviews here and watched a YouTube video for the same product from a different seller. I had no problems at all and they look great. I think the key is to give the truck and the decal a light spray so it can be scooted into place and then go very slowly when smoothing out the bubbles and peeling the backing.

I couldn't tell which side to peel off and since one isn't transparent like in the demo video. As I result, I messed it up. They're so cheap i'm going to try again, but be more careful which side I peel off first this time.

I love the fender flags! I had a hard time getting them to come off of the clear side after applying them to the fenders. As you can see from the photos that I didn’t get them placed exactly right but that was my fault I’m sure. I am happy with them inspite of that.