TNP Home Theater Speaker Wall Plate Outlet - 7.1 Surround Sound Audio Distribution Panel, Gold Plated Copper Banana Plug Binding Coupler, RCA LFE Jack for Subwoofer, HDMI 4K ARC/eARC Full HD (3-Gang)

This is a must-have for in-wall wiring of your surround. I chose this one because I installed a 7.2 system with gold-plated jacks and it worked out great. You can get almost any combination of HDMI, subs/surrounds that you need (5.1, 5.2, 7.1, 7.2 etc). Do your planning on location and wire-routing; get good quality speaker wire and HDMI (high-speed with Audio Return Channel); get the remod-style mounting bracket/box then cut your hole at the same height/level as your electrical outlets and preferably between the same studs as your TV's wire-box so your HDMIs just run straight up to the TV (remember to install the bracket BEFORE you run your wires). When connecting the wires to these terminals, it's best to have 10 to 12 inches of wire coming out of the wall because you need space for your hands to manipulate the wires and nuts on the terminals. If you have a basement with access to the floor below the mounting location, it's best to drill 4 half-inch holes straight up through the bottom plate of the wall and feed your wires up those holes. Tip: If your TV and Surround Receiver are fully compatible you really only need 1 HDMI port on the wall plate, because you can plug your devices into the receiver and just sent the A/V/data to the TV while the audio is returned over the same HDMI.

My only complaint is that it wasn't available in black as it's in a dark walled home theater. However, it's behind the receiver so it's not real visible. It worked as expected and definitely kept the wiring neater and allowed me to run it through the walls.

Good quality, I wish the sold the individual outlets because I had to buy multiple just to get 11.1 surround connections.

Would have liked to use keystone inserts but this was a good alternative for the cost. Just 1 set of keystone for speakers where $10 bucks and I was able to use coax blanks and the speaker inserts from this at a 3rd of the cost.

3 hdmi outputs were a bit overkill. Ended up swapping for keystone plate with a cat6,hdmi, coax

This worked great. I love a clean look. So I wired all the cables into the back side, in the wall. Not it looks clean and origional, like it came from the builder. I got the house and there were just a bunch of wires hanging out of the wall. This cleaned it up perfectly.

All of the tightening barrels for the bare wire install strip out when I tried to tighten down on the wire. Not just one or two but all 14 connectors failed. Very poorly made.

It looks cheap and feels cheap