Hantek Current Clamps Series (CC650)

I had to purchase a 1ft bnc jumper cable to use this product because the bnc end they used was fatter than a standard Bnc female and wouldn't fit in the recessed BNC port on my scope. Only taking off one star because it otherwise works great and most scopes I know don't have recessed ports.

Used the probe to view engine starter current. Meets expectations at a reasonable cost. The frequency responce was adequate to clearly capture solenoid engagement current, starter inrush current, engine cranking current and cranking termination.

I tried this on a known active AC line, one side only. I got no output at all from this probe. Sent it back.

Good probe! Not to be confuse by the box. One box show two model and two pictures.

bought this to use with new pico scope,works great doing starter draw test, great value,well worth the money

It's max range is 650 amps. So be prepared to make a times 10 adapter

Purchased this with Hantec 1008c. Complete junk.Maybe it was the scope I was using. YMMV if using with a better scope.Stay away from Hantec.

Excellent seller. Excellent product.

Excellent product smaller model also, only one thing, the switch is cheap, people with experience can replace it with a better switch. The probe respond in high frequencies also, so good to mesure fast amperage.

I couldn't get this to work on my Hantek 8 channel ocilloscope reliably so I returned it.

Good but over price.

Bought this to go with my Hantek 1008C. Works good and allows to check ignition secondary on older vehicles (not coil-on-plug) and current draw while cranking!

Cable can improve in quality but works well..