1-1/2" Wrought Iron Patio Furniture Feet Caps - Round Plastic Outdoor Metal Table and Chair Floor Protector Glide Replacement Parts (24 Pack)

-Worked out great. Didn’t need soften them up - but left them in the sun on purpose while scraping out the original ones with a paint scraper followed by a stiff bristle brush to ensure all the dirt / pollen was removed. Did six pieces/24 legs without any issues.-While folks recommended pliers to fasten, i didn’t need them. Instead, once i was able to get them attached i’d flip the chair / table back over and use the rubber mallet method with a block of wood to avoid damaging the paint and to have them permanently snap in place.-I did have one deformed metal caster so I ended up siping one cap to get it to insert… then tapped like the rest of them.-So, _rubber mallet or sledge, _block of wood, _box knife, _stiff bristle brush, and a _scraper. Easy work- :20-:30 min tops for all six. Would recommend to anyone.

Our wrought iron patio set was recently refurbished but it needed new caps on the legs. These fit perfectly and they protect the chairs, tables and deck! We are VERY pleased. They snap in with a bit of a tap from a hammer and are snug fitting!

I had no problems with installation, but I did use a pan of hot water first. It was two different styles/brands of furniture, and one was a little tighter than the other. I did use my rubber hammer after they were aligned, and started in the holes.

All but one tapped easily into the bottom of my 1 1/2" ID chair and table legs cup. Product not at fault, the bottom of the leg had a little bit of wear ( Internal Burr) from not having a cap for couple of yrs. All I had to do was de-burred the ID of the leg and the cap then installed correctly. Not as thick of material as I thought they would be. My Original leg and table caps are15 years old and only 8 of 20 of them needed replaced. Have to wait and see how these wear on Cement patio..

They were a little bit hard to get on but that's how you know they won't pop off easily. Have only been on for a week so don't know about quality yet but so far good product.

I lost 2 of the feet caps from my glider and was very happily surprised to find these. There are 8 in the package so I can afford to lose a few more. Thank you!

Like many other comments, these were somewhat difficult to install, but with the aid of very hot water and a small hammer they went on satisfactorily. The issue I'm having is the lack of traction between the new chair feet and my deck - there is none which I feel is a significant safety hazard. I might try scuffing the feet with some fine sandpaper.

Great product. Fit the iron table legs perfectly to protect our artificial turf. Product was as described and arrived promptly