RASTP 64Bit PC USB Handbrake SIM for Racing Games Logitech G27 G25 G29 T500 T300 Fanatecosw LFS Dirt RALLY.2, Black, Without Clamp

purchased this for my sim drifting rig with a g920 wheel, this does work with the g920/g29/g27/g923 if your using it on pc this does not work for xbox or playstation 4/5 unless you wire it to the button on the motherboard of the wheel, so far the thing is amazing. theres a couple reviews on here talking about the usb cable being held in with glue and that is not the case at all, it has a cover that the pcb board is held on to and that has a slot for the cable to stick inside and be held down firmly, ive been yanking on this for the last 5 hours straight and have yet to pull any cords like others clamed, this is truly the best bang for your buck, the only con about the whole thing is the guide bolts on the side tend to rub on the metal housing of the unit causing slight noise when pulling the handbrake hard, ive fixed this by adding a tiny bit of dielectric grease where the two points make contact and has helped alot

just bought my second one after 4year of ripping it and gotta say they refined it since much better quality and solid its powder coated

Returned Item, This could easily be a winner... but the sensor only calibrates (reads) to 60 percent... the point is to lock the back wheels... if 60 percent doens't do that wtf is the point of using this as a handbrake? Also how hard would it be for the manufacturer to simply TEST the damn thing before final packaging... it would literally take 2 minutes and not waste my time. My old one was a similar brand, I got 2 years out of it but now the thing Reads when not being pulled....without even the most basic software to tweak or adjust around these issues... I would personally avoid any of them and save up for a legitimate brand item, Thrustmaster, logitech, Fanatec etc.... or you are just rolling the dice with these.

Two stars for the build quality, which is not bad. The rest is bad, The box was missing the instruction, came used, and didn't work. Every screw was loose on the devise, Every screw! I was able to turn bolt's and nut's with my bare fingers, only two screws were tight. The device was missing the manual and came with grease smudges and hair stuck in it, on top of that it did not work. I did troubleshoot it and the end resault is the sensor isn't working at all. on top of that I bolted in to the rig before testing, so it was awful to do all the work and getting absolutly nothing good from it.

Defective from the start. Comes with a cheap USB cable different from whats advertised and the USB cable is plugged directly on the circuit board micro SD port without any good support. When plugged to the computer, the system and all games recognize the controller as a ANNX handbreak but the magnet sensor does not work. When doing the test in the game controller settings and trying to calibrate the hanbreak, the slider is at 100% regardless of the lever position. The aluminum construction is OK but the arduino module and mounting plate could use a better design. Returned it right away.