How to use: 1. Either solder the POWER SUPPLY AND PROGRAMMER board to the ESP-01 or buy an already soldered board from our store. 2. Connect Transmit and Receive pins to a UART device. Connect ground if you are supplying power from the input power pads or the batter connector. 3. When you are ready for programming just press the program button, the blue LED will flash indicating that you are in program mode and send the program! The Power supply and Programmer board is a companion board to the ESP-01 (ESP8266). The POWER SUPPLY AND PROGRAMMER board fits on the bottom of the ESP and allows you to program the ESP without wires and large breakouts. A reset button is also available so that you can rest the current program without jumpering or powering down the ESP. The POWER SUPPLY AND PROGRAMMER board comes complete with a voltage reducer that can take up to 15v DC and 0.5A; on either the solder pads or the battery connector. You can connect LiPoly batteries or your own power source and not work about the ESP breaking down due to over voltage. Specifications: • DC input up to 15v • Current supply of 0.5A to the ESP-01 VCC pin. • 0.2mm PCB thickness
A**W
so far so good can't get the unit to program mode but the ...
so far so good can't get the unit to program mode but the reset and batterty terminal works just fine
M**W
Good buy
Good product for a good price. Works with no issues so far. Used with li-poly batteries.
Trustpilot
1 day ago
2 months ago
