Flycolor 60A ESC 3-6S Electric Speed Controller 5v /6V/7.4V 5A BEC with XT60 & 3.5mm Bullet Plugs for RC Drone Airplane Brushless Motors

alles wie immer tpo

I've had wonderful experiences with Flycolor's compact 50a esc on several smaller, 4S EDFs, so I thought I'd give their 60a esc a try on my 48" 4S 3D plane. I've been flying that model with a Hobbywing Skywalker 60a esc, which is their least expensive 60a, and I experience great performance when it comes to punching out vertically. I literally just swapped escs, calibrated the Flycolor 60a, and flew. My model felt like I'd easily lost 10-20% power and top end. It was as if my lipos were old and dying. I flew at least a dozen flights with several different batteries, with different "C" ratings, and every flight was the same. And the final disappointment is that the 60a Flycolor ESC is also bigger and heavier than just about any other 60a ESC I've ever bought.So yeah, back in goes the Hobbywing Skywalker, and into the "old escs I'll likely never use" box goes the 60a Flycolor. 🙄

Like the pnp of the unit...well built

This ESC stopped my RC plane motor twice on full throttle 6S take off while emitting a screeching noice. It restarted when I pulled the throttle stick back and then forward again so at least it did not cause a crash.