Anycubic Photon Mono 4K LCD Protective Film - 5Pcs, 0.1mm Thickness, Compatible with Anycubic Photon Mono 4K 6.23inch SLA UV Resin 3D Printers

Many moons ago, when I purchased my first Photon Mono I did not check to see if there was a screen protector added. I mistakenly assume that this would be done by the manufacturer. Silly me. So, I lost that screen when a resin model fell off the build plate, sitting at an angle on the bottom of the tank and was crushed through the FEP in the tank when the build plate came down for the next layer. Lots of resin, huge mess and it was impossible to rescue the screen as it is coated in a rubber sort of substance.Lesson learned.Interestingly, the second Photon I bought had a screen protector fitted. So, not sure what happened there.Since then though, I have always made sure to have this sort of product handy in case of spills or accidents. This one though is definitely the best that I have tried. It is extremely clear and better made than others I have used.It is not, unfortunately, any easier to fit.I utterly despise having to fit screen protectors to anything. We do not have a clean room in the house - by which I mean a sealed area, free of particles and/or moving air. As we also have two dogs, it makes it even more challenging. Not impossible, just challenging.I have slowly, over time, discovered a method that works for me and I am not managing to get this sort of thing fitted without air bubbles or dust particles creating problems.Having fitted one of these to a photon that required a new screen, I believe that it has made quite a difference to the machine. Previously I was getting a little bit of blurring of details on the models I was printing (primarily 28-32mm models for wargaming.) This screen, perhaps, being clearer than others I have used, is allowing light through more efficiently. Whatever the case, prints are definitely sharper and clearer than they have been. If that is due to these screens, then it was definitely money well spent.You do get 5 sheets for the price, along with everything else you need to fit and secure a screen protector. I cannot recommend these things enough. I know too many people who don't bother with screen protectors. The downside of that is if there is a leak, and you can't clean the screen properly (which cannot be done on the Photon Mono) you are facing an expensive repair bill for a new screen.Always, always have spare screen protectors. You never know when you might need to replace one, and you should never use a resin printer without them.

As described

Contento

Bien suivre le mode d'emploi.Enlever l'ancien film et son contour noir.nettoyer l'écran avec un peu d'alcool isopropylique (fourni sur des lingettes)Prendre une des protections neuves, enlever la pellicule inférieure et poser immédiatement la protection en la centrant comme il faut. Chasser les bulles vers l'extérieur avec une carte de crédit.Enlever la protection supérieure.Ajouter un entourage noir (attention aussi au centrage). Et voilà....

Great buy. Great film and has the gaskets included. Hard to get the bubbles out, but that's the nature of any of this stuff. Will be purchasing more. Just a warning. It's okay to purchase this aftermarket LCD protector for the Anycubic Mono 4k, but I DO NOT recommend using the aftermarket FEP film for the resin vat. Purchase the ready made FEP already mounted to the metal plate bracket made by the manufacturer. It's more expensive but you'll regret it if you don't

Decent quality and you will definitely have to extras on hand especially if you get a pin hole leak like I did

Es un protector, cumple su función y encaja perfectamente.