RZR Flag Mount

The product exceeded my expectations from the description on Amazon The basic mount is a product I have used on my RZR already so I knew what that would be, but the the stainless steel bar was way more heavy duty than I thought it would be. In my case I mounted the Tusk 1/4" flag mount system base and it fit perfect. The overall mount is solid in the RZR mount holes and I have been able to move it around to try out different locations to optimize my flag mount. (This is not so easily done with other mounting systems.) Because of the winter weather here I haven't had much opportunity to field test my installation but so far so good. I'll submit an update if I have unforseen problems. I don't anticipate anything at this point.

Excellent

This flag holder is very very well made and works awesome on the 2011 Polaris RZR 800S I own. I now have purchased two of these and will say again it is very well made. I is solid and fits my RZR 2011 800s perfectly. I 100% recommend these for mounting of your whip and flags.

I have a 2001 Polaris 500. While the unit WILL work, it doesn't actually "fit" the holes/spaces on the rear or front racks. This isn't the company's fault, it just doesn't fit my older ATV like it's made to. GREAT idea, EASY to use!!!

You have to crank the knob quite a bit to get it snug which makes it more work to install than Polaris Lock-&-Ride (L&R) which is just a quick throw lever. But the plate where the base of the pole mounts on the L&R is thin enough that wind pressure on the flag bends it and the flag ends up angled back significantly after some riding. The plate on this is many times thicker and should hold up against the wind pressure much better. However, removing the mount after use is a bit of a problem. I found I am unable to withdraw it from the mounting hole. To remove I had to disassemble the mount, removing the knob, plate and washers, and push the body down through the mounting hole and recover it from underneath the RZR. So, removing the flag when finished will require some work.

Works great and takes 10 seconds to remove!!

I made sure this item was for a Polaris RZR - however when tightening the mount it simply moved up through the hole. - it will not securely tighten. The rubber does not collapse/expand good enough to stay in the factory hole. It was not secured even after the screw was 50% up into the rubber, the mount and flag fell out after 10 minutes of riding. The bottom screw was 1/2 way into the rubber mount and failed !

There’s nothing to dislike about this flag mount. Easy to install, sturdy, and priced well. I used it recently at an off road park and it stayed put. I hit whoops and tree limbs and it didn’t pull loose. Good flag mount!