VKO Red Soft Metal Shutter Release Button Compatible with Fujifilm X-T4 X-T30 X-T3 X100F X-PRO3 X-E3 X30 X100T X100S Camera 11mm Concave 10mm Convex Surface(2 Pack)

Fit well and have nice deep red, doesn't stand out too much. Make sure you tighten it well.

Purchased these to replace missing shutter buttons on a couple of my old 35mm cameras. These worked well for my Olympus Pen-EE half-frame camera and my Grandpa’s Olympus OM-30.

I have the Sony RX10iv and these fit perfectly (without the rubber washer). The concave one is my favourite - both look good as not ‘bright’ red, rather muted.

Bought for shutter button on Sony camera makes button easier to locate.

Has a short threaded screw to insert into the shutter button. It has come off a couple of times due to not being tightened enough. Difficult to get it tight as I don't want to force it. You have to hold the camera power-on firmly to provide resistance to screw it firmly into place. Comes with a very small, in fact minute, rubber washer which you have to fit over the thread. This is fiddly and I found that this made it less likely to keep the button in place as it shortens the thread further. However it does look good on the camera and is functional but to be honest I'm not sure it is necessary. Camera is Fujifilm X-T30ii. Two of them in the pack incidentally, one concave and one convex. Advise you keep the spare handy.

Nice little addition to my Fujifilm camera.

Nicely made and good value for money. I have other buttons with faux leather tops but this one feels much better. The thickness isn't so much to raise it too high above the other camera controls (Fuji X-Pro3) but still nice and solid. So far it hasn't come loose.

Does not fit