PCIe Expansion Card USB C 3.2 gen2 10Gpbs with 3 USB C & 2 Internal Port(1x Type A, 1x Type E A Key) for Desktop PC

Working very well. Coping speed up to 160mb/sec.

It's a decent piece of kit and does what I wanted it to do.

Installed into a MacPro 5,1 (Ventura) with speeds of 10Gb/s and 900mA available. No drivers needed

PC won't boot after mounting on a TUF motherboard, had to remove the card to be able to boot again..

Didn't work in any pci-e slot, would provide power but no data. Wasn't recognised in the BIOS and the drivers didn't work. Nice backplate.

Utiliser sur un ancien PC pour avoir de l'USB rapide, bon, vu le PC et ses autres composants les 10 Gbs on oublie, mais pour le reste, l'installation est enfantine, la carte est fournis avec un second "arrière" pour s'adapter au Mini PC, à vue d'œil, les soudures et les composants de la carte font qualitatifs et sont propres (j'ai pas pousser le vice à vérifier les référence ^^). Windows 11 a reconnus et installer la carte de façons transparente et les prises sont bien alimenté pour charger un tel avec une puissance correcte (pas de "super charge" sur ma config, donc pas tester) Bon produit, j'en suis totalement satisfait.

Plug in and play, that simple in Windows 10 Works fine for me 😊

Ho acquistato questa scheda per aggiungere delle porte usb c al mio pc che ne era sprovvisto, il tutto funziona perfettamente ,scheda madre asus z97-pro wi-fi ac trasferimenti a 10 Gbps . Se si utilizza tale scheda per fare dei backup di immagini di dischi o partizioni su ssd esterni utilizzare software aggiornato che riconosca la scheda e ssd esterni dalla velocità di trasferimento adeguata.

Pas facile de trouver les driver Le disque fournit envoi vers des sites dangereux

The card works properly and is auto detected on Windows 10 (no drivers needed.) The one very negative point is that the Type E connector, to connect to a front IO USB-c port, is "floating" in a cut-out on the PCB, only held on to the card by 4 small solder points. It is not fixed to the PCB more than that. The front IO cable for the USB-C in my computer case is a bit stiff and was able to pull the e-type connector off the card without any effort at all. I was able to slide the connector back over the wires and, as I purchased this card specifically for the Type E connector on the board, I'll try to solder the connector back on. Otherwise the card looks really good and the ports on the bracket seem to work fine. Such a shame. :( Addition on 2024-08-15: ----------------------------- The seller contacted me and offered a full refund. As I was able to get the connector back into a working state, I have declined their offer. I do consider it good service to offer the refund, so I wanted to make a note of that here.