DTECH USB to RS422 RS485 Serial Port Converter Adapter Cable with FTDI Chip Supports Windows 11 10 8 7 XP Mac -1.5 Feet

So say you have a bunch of industrial control and alarm panels that absolutely need an RS-422/482 serial interface to allow you to program them. Say the original vendor wants to set up a contract for many MANY monies to come out and do that for you. As I've said before - nu-uh. You spin up one of these babies, slap it into a laptop, add a couple of connectors, and as they say Bob's your uncle! Worked great. Came with software I never bothered to install. Got the job done. Sittin' there waiting for another ICS to program...

This works great for what I needed it for (programming LED text signs).

I needed to replace my old RS485 to USB controller and my software vendor suggested this model. It work perfectly right out of the box. It comes with a driver CD but I did not need it. Also included is a breakout box to adapt between the 9 pin type D serial connector and the RS485 twisted pair cable. I did not need to use the wiring block as my RS485 cable was already terminated into a female 9 pin connector that mated perfectly with this RS485 adapter. Literally a plug and play solution for me. Love it!

Quality very well . Better than I expected from china’s stuff.But as it is a quality part just a sliver of writing would go a long way…

lots of other options - a few of them didn't work for me. This one worked right out of the box with no drama. windows 10, no need for drivers or anything else, plug it in, it gets recognized as a com port and my ancient plasma software shows 'plasma online' and I can adjust the amps, air pressure, & get plasma status and error codes!

It works! It took me awhile to figure it out, but once there it was more of less obvious. It helps to look at the FTDI reference design for the 422 converter, and as remarked (and in one line of the user manual), 120 ohm termination resistors are recommended at the end of long high speed cables. In my case, needing to connect to a Garmin 19x at the end of 30 meters of cable, they weren't needed. The 'trick' that took me forever was that I initially connected the Garmin TX to the DTech TX lines -- didn't work. Swapped the polarity and lo and behold I could see data. But I then couldn't send messages to the Garmin. After some down time thinking, I correctly connected the Garmin TX to the DTech RX and the Garmin RX to the DTech TX and it all worked. I did have to swap polarity too, but now everything works great!

I bought it for BACNET communication in RS485. It works as intended.

I opened the package, plugged the USB cable into my Windows 10 machine, and viola! Windows found the drivers and behold I had a COM port listing for the adapter. With a terminal program I was instantly transmitting and receiving. I uses it for experimental work with microcontrollers. As one reviewer mentioned, the lights blur into each other. I might try his trick to open the case and put heat shrink tubing over the sides of the LEDs, but really not a big deal, anyhow.

安価で不安でしたが、問題なく使用できています。良い買い物でした。

Needed to test an ASCII laser sensor before connecting to PLC. The sensor required a separate 24V power supply in addition to RS422 4-wire connections. Device worked perfectly, the RX\TX light indicators were very useful when first connecting the device to determine correct wiring; the labelled terminals also a nice sanity check. No problem installing the drivers in windows 10 1809.

Good

converter performance is very good , the price also is reasonable

問題なく動作しました