Front Strut Tower Cover

Great value and finish, fit perfect.

I cleaned the area where they meat the strut housing and pealed the plastic where the 2 sided tape is and just put the covers where they go.The heat from the motor softened the glue on the tape and they are on there well.No screws needed.When ever you get to where you going or coming open the trunk check that they are on well. Its been 2 days and they look great same color as the engine bay (i got the mat black).PS you don"t have to push down hard on the plastic strut cover.2024 c8.hope this helps.

If you have mag ride you will need to notch for wiring and doesn't fit exactly flush , but looks way better than nothing there

Had to do some work in order for these to fit properly. Cover made contact with the outermost bolt on both struts which caused the covers to rock a bit and not sit solidly. Cover is not deep enough to accommodate taller bolts. Had to drill a small hole to allow the bolt to stick through the cover in order for the cover to sit properly. Also, the yellow covers don't match the color of my accelerate yellow C8. Still not sure if I will install.

Fits right over the strut mounts, need extra bonding material, otherwise perfect covers, factory should have provided these originally

If you have Rapid Blue, don’t bother! The blues ones in the photo look nothing like what I got which was a darker blue. So returned them. Aside that, they seem well made and fit good.

This will not fit if you have magride. There is no opening for the connector.

Looks much better and fits perfectly!

Looks good but is hard to color match with other engine dress up stuff black would have been better