Naze32 F3 Evo Brushed 32-Bit Flight Controller for 1S/2S 720-1050 Motors

I bought 3 of these to get better at IRL fpv flying in ACRO mode. I built a 90mm & 100mm brushed quads with 8520 motors. The third FC board is for backup. I have put multiple hours, crashes, motors with these and no issues. I flashed betaflight SP3 Evo Racing. They come shipped with a decent single paper layout/manual. Boot/flash: To get into boot I used tweezers to jump the bootpads. In firmware flasher of betaflight I selected latest SP3 Evo Racing version. It was pretty simple. Betaflight: I used default everything from the version I flashed. except I turned on motor stop on and set motor pwm to 23000. Motor layout: i used quadx in betaflight motors 1/3 CW motors 2/4 CCW Receiver: I used flysky FS82 ppm receiver soldered to UART2. FPV/VRX: I soldered right to the battery leads and have had no issues. Know the voltage of your fpv/vrx.

Worked for one or two flights before 5 volt regulator went bad. If you're looking for a new Bingo chip, this is perfect. If you're looking for a flight controller, look elsewhere.

ok for the price!

HELP ME!! So I got everything all soldered onto the board and went to bind the drone to the transmitter. But as i was holding the bind button and went to plug the battery into the drone, the motors immediatley power up and start spinning full throttle as soon as i plug in the battery? if anyone has any insight on whats going on or what i did wrong it would be MUCH appreciated!! thanks

Running 1S, Betaflight3.2 (Stock PIDS), 8520 motors, Ladybird props (55mm) & buzzer. Added a 450mah 3.8v HV Lipo for added fly time. Getting 3-4 minutes flight times. Need to finish with FPV camera w/ VTX. Flys great, perky little fella. Getting the USB setup on the FC and flashing Betaflight were pretty straight forward. If u need help, search Youtube for "F3 Evo Brushed Flight Controller" and lots of help available. Next one will be jumped for 2S.

Nice small board for my 3D printed drone. I have bought two of these and about to purchace another.. great little flight controller for brushed motors!

Used for quad. Works well but no osd.

I have now purchased two of these flight controllers and neither work! Running on 100mm brushed quad and both FC came with 1 of 4 motor ports not getting power. The second one is motor #m4 and the first I bought was no power to m2. If you do buy don't waste time and check with voltage meter prior to even installing to check if power is even getting to the motor pads. Seemed like a good buy at $17 now disappointed after $34 spent.