Thermaltake Commander FP SATA Powered 10 Port 4-Pin PWM Fan Hub AC-023-AN1NAN-A1, 3.2 x 1.7 x 0.7 inches

Super easy to installCame with ties and little adhesives to place anywhere.And it just works, that's what matters most, you plug everything in and it just works well.Good product from a brand I trust.

It works, unlike corsair and other hubs that always have2 or 3 ports that don't work, this one came with all the ports working,

Device works as advertised. Only drawback was a SATA power cable did not come with the device. Once cable was acquired connected the device it was detected in the system BIOS. Made a couple of changes and it is currently controller four fans installed in the computer chassis. Outside of the SATA cable, very please with the purchase.

Bought this for my gaming PC. I needed to install more fans on my PC but didnt have more ports/pins available. This worked like a charm, works great, easy to set up, easy to conceal.This is a 10/10 product.

I was skeptical at first when I saw someone caught this product on fire. I honestly laughed about it, as this product works great for my fans in my case. You just have to plug the header coming from the device into a fan header on your motherboard that isn't your main CPU fan header. READ YOUR MOTHERBOARD MANUAL before installing to a fan header on your motherboard. This product is great for my use and all the fans speed up and down as they should. Make sure you have PWM mode enabled for the specific fan header you plugged this device into so all fans can work properly. I would recommend this product to anyone who needs a PWM fan splitter.

I ordered a very similar competitor just because it was cheaper by a few bucks. It came DOA so I decided to go with Thermaltake instead since they're at least a name brand. It just works. I don't know why everyone says that PWN doesn't work as it works perfectly fine in my case. You NEED to have a PWN fan plugged into the 1st fan port on the hub for PWN to work. The PWN info from the motherboard ONLY goes to the 1st fan slot and then all other 9 slots get the PWN from the 1st. If you don't have a PWN fan plugged into slot 1, all fans will run at 100%.

This is a handy tool if your motherboard doesn’t have many fan headers. It’s great for expanding your setup and powering multiple fans from a single SATA connection. However, there are a couple of downsides that are hard to ignore. The biggest issue is that you can’t control fan speeds individually, all fans run at the same constant speed, which limits customization. The included adhesive is also pretty weak and didn’t stick well at all. The Velcro they provide isn’t much better, so you might need to find your own mounting solution. That said, it does what it’s supposed to do, and for the price, it’s still a functional and worthwhile piece of hardware. Rating: 3 out of 5 stars.

I have been using 2 of these for a few months now, powered by separate sata cables, powering 10 noctua fans on each fan controller at full speeds most of the time. These have been very reliable and do not get warm to the touch either. I have them stacked ontop of each other to save space. Not many name brand quality fan controllers available these days I can vouch that these are safe so far and work. You cannot control each fan individually, it follows which ever fan speed is connected to the shiny/glossy port.