Case for Raspberry Pi 5 with Space for Hats, Add-on Boards, Coolers, and NVMe Hats

Its got loads of room and the PI 5 fits perfectly. Beware of returned items though as I bought this, expecting it to be brand new and was shocked to find rounded off screws and two of the built-in case stand offs with headless broken off screws in them. I have still managed to use the case but was a little disappointed on that front

I was not able to properly close the box with an nvme top, it was a useless order for me. It doesn't properly fit with a rasberry pi and a hat added. the screw and poles are not providing a good solution to attach a nice top.

Picked this case for a Raspberry Pi 5 with an AI Hat+ installed on it. There are no instructions, so you have to figure it out on your own. If you have a lot of electronics experience, it’s fairly straight forward. If not, maybe the following will help you out. This is what I had to do with the AI Hat+. Other Hats may be different. The case comes with two different length standoffs with a stud end. One set of 4 must be used to hold the Pi board to the bottom of the case. The 4 mounts inside the case are threaded and not through holes. So the Pi must be mounted from above. If your Hat is installed with the nylon standoffs it came with, you have to remove those and use the longer metal standoffs that come from the case. I did not use the shorter stand offs at all. The case also comes with a header pin extension. For the AI Hat, you have to remove the longer extension that it came with, place the shorter extension that came with the case, and then add the longer extension back on top of it. They won’t fit if you stack them the other way around. Getting the ribbon cable attached between the Pi and the Hat is tricky. Disconnect the cable from the Hat, but leave it attached to the Pi. Mount the Pi with the longer stand offs, and install the stacked header extensions. Next start the Hat onto the header pins while keeping the ribbon cable against the front of the case. Before pressing the Hat down onto the pins, get the ribbon started into the socket on the Hat. As you press the Hat down onto headers, feed the ribbon into the socket. It may take 3 hands to get things lined up during this process. After the Hat is in place, use the 4 metal screws to secure it to the top of the standoffs. Note that the AI Hat is a bit higher that the stock configuration, but that only gives it more space for air cooling. There is still a lot of space over the top of the Hat once the top of the case is installed. There are 4 stick-on rubber feet for the bottom of the case. There are 4 threaded mounting holes on the bottom and 2 on one end of the top. The bottom also has 2 plus-shaped slots that appear to be for blind mounting on a vertical surface with small pan-head screws. Overall, it’s an excellent case that looks great for my set up. Very functional addition to a Pi 5 for your project.

Ein gutes, stabiles Gehäuse für den Raspberry Pi 5, wenn man auch eine ssd unterbringen will. Man muss sich allerdings klar sein, dass man viel schrauben muss.

An excellent case for the Pi, my only beef was that I already had the HAT mounted and had to pull the pi apart to fiddle around with the screws to get it mounted properly in the case. The standoff screws that came with and are needed to mount into this case properly are a touch too long for the HAT that I have, and the ribbon between the Pi and the HAT was a little shorter than it needed to be for the standoffs. The HAT is a tiny bit longer than the case allows for, so I can't screw the top of the case closed on the side where the M2 screws down - which is OK for me because I swap out the M2 drive regularly and it just means less screwing to worry about.