XMARK Heavy Duty Adjustable Rotary Leg Extension and Curl Machine Features A 12 Position Adjustable Thigh Pad and 20 Position Adjustable Press Arm

Yesterday this leg extension machine arrived. It was in 3 very well packed boxes. They do d a great job equally distributing the weight so it was easy to carry to my basement gym. After unpacking all of the parts I was struck with how well it is made. The square tubing is very thick as are the interface plates. The design is well thought out as are the assembly instructions. The padding is on par with commercial equipment. It took about an hour to assemble. After completion I did a few sets and was pleased with the feel. It is the nicest piece of equipment I own and I’d definitely recommend it!

Great machine. This was fairly easy to assemble with clear directions. The machine is very sturdy and strong. There is no wobble or cheaply made parts. Comes with Olympic weight adapters. There isn’t a collar for the Olympic weight sleeve but the weights stay on without one. Range of motion is good with lots of adjustments to accommodate comfort and size. I’m 5’10” 180lbs and can see where someone bigger or smaller to a certain extent would have no problem adjusting. Very satisfied and highly recommend paying the money to get this quality machine over the cheaply built alternatives.

This is super sturdy. Two parts had problems, and the seller IMMEDIATELY shipped replacement parts by FedEx. 5 STARS to seller. Only 4 stars to product... because of ONE con: As others pointed out, the bottom leg cushion support bar is about 2" too short (not long enough on the right leg side). It DOES sometimes make you worried your leg will slip off. My shin is RIGHT at the edge and others of similar size may have the same problem. I am 6' 230lbs (bodybuilder), and so my legs are not thin/small - and thus the issue with the lower cushion. It *barely* fits/works...I have thought of some slight mods I could do, but will use as is for now. The good is... it was EXACTLY what I needed to add to my workout home gym that I have built up over the years. This thing is VERY sturdy/solid, as well. All said and done...and as I mentioned... 4 stars. (Note: I paid a much higher price after bidenflation pushed the price up by an EXTRA 150 since last year...so I paid over 750 for this (!) thanks for that...)

Bought this for my husband for Christmas and it has good adjustability and cushioning. It's just what he wanted and we both can adjust it to our leg size and range of motion. Good quality and good buy.

I was going to a personal trainer for the past 15 years and after numerous injuries with my back (herniated disc), shoulder (Labrum tear) and finally blowing out my knee, I abandoned the personal trainer and put in my own home gym. Since my knee surgery, I have been in so much pain, gained a ton of weight and lost all my muscle. This machine has been a life saver in helping to rebuild the strength in my legs without all of the pressure lunges and squats was putting on my knees and lower back. It came packaged INCREDIBLY well. It was super easy to put together (although it did take my husband and I to do it as there were times you needed more than two hands), It's incredibly sturdy and I would put it up against any machine in a commercial gym. I also purchased the weights that are recommended to go with it. I couldn't be happier.

I am very happy with my xmark leg extension and curl machine. My physical condition is probably different than most: My whole spine is fused from c2 to s2 and getting around machines is often difficult. I have built a good home gym but have not worked quads and hams for almost a year but now ten years of surgeries are finished and I'm healed enough to start legs again. It took some effort to find the best seat positions, pegs to pin and a way to get the knee pads inserted while seated, but I did and now it does everything I want. This can easily hold enough 45lb plates for anyone and it is very solid in use. The hand grips are a bit low for me, but I can reach them. I am only 5'10", but 265lbs and have been a bodybuilder when I was younger. This machine is probably going to wear very well and stays solid and smooth even while using heavy weights. The only cheap pieces are the plastic sleeve inserts and the knee pads post is undersized and wobbly. I will probably make my own from better-fitting square tube steel. One other annoyance is that I havr to remove this knee pad piece every time I want to get off the machine. There are better, adjustable knee pad designs in more expensive machines but this does work. The knee pads themselves could be a little firmer: I like a snug fit when working hamstrings and the soft pads have quite a bit of give. The leg extension shin pad is very comfortable even using 230lbs(the most I have done so far). Overall, this is very solid, smooth and heavy duty. It is adjustable and should be a good fit for everyone.

This machine arrived faster than expected, which is great. It is sturdy and it was easy to assemble too. It has good ROM, better for curls than extensions I think. The weights do slip off, I can’t find a clamp that fits to keep them from sliding. It also is a bit creaky but not a big deal for me. Also, with extensions, it is a bit hard to get left foot in bc the bar below the seat kinda makes it difficult. Again not a big deal but it has scraped my ankle a few times. I do recommend, if you are looking for curl/extension machine similar to a gym.

Like many trying to figure out a way to work out during COVID, exercise equipment can be very difficult to come by these days. Maybe because these were leg machines they were available (terrible gym joke), but training legs with weight in addition to body weight can be difficult; especially hamstrings. The equipment came as promised, both machines were easy to set up, and I am more than satisfied with the quality of the machines. These are quality additions to any home gym. When the packaging arrived, one of the weight sleeves was dented, and the tough texture on the calf raise machine was falling off. I don't suspect this was the fault of the seller. I contacted the seller on Amazon to explain the situation, they replied within 2 hours, and they gladly shipped out a new sleeve and a new adhesive for the calf machine. The replacement pieces arrived within a week! Couldn't ask for more!