🎶 Elevate Your Drive with Premium Sound!
The Ai HSB524 Speaker Adaptor is designed for 2006-2011 Honda models, allowing for the installation of two 6.5 or 6.75-inch speakers. Made in the USA from high-quality materials, it ensures a perfect fit and durability, complete with all necessary instructions and hardware for easy setup.
M**R
Great fit
These were easy to install and were a perfect fit for my Civic.
1**H
works great
very good
J**O
Product worked well. Fits the 2023 Honda Civic
I was not sure if this item would work on my car, but I am glad I ordered it. This item works on my 2023 Honda Civic. (Fits Front and Rear Doors) The only thing I would say is that I wish it had a solid flat base so the foam tape I purchased separately has a flat surface to stick too. Otherwise, this worked perfectly and saved me a lot of time. Mine even came with hardware.
S**S
Worked well with easy modification for 2009 Honda CRV
Installed in my 2009 Honda CRV. I had to modify them to work with the new Rockford Fosgate 6.5 in speakers by cutting the inner tabs out and then drilling holes in the plastic to match up with the speaker mounting holes, no big deal. I was able to use speaker mounting tape on the underside by just applying it to the both narrow strips of plastic. Seemed to seal to door as it should. Speakers sound great with these.
B**N
Good for upgrading speakers!
I used these in a 2013 Honda Pilot. I replaced the stock speakers with aftermarket 6.75" coaxial speakers. The screw holes were not an exact perfect fit for either pair of speakers that I have (Alpine and JVC), but were close enough to get the job done.
M**E
Car Speaker mounts
fits really good and very easy for 2016 Honda CRV
O**
Fits a bit tight and plastic is very brittle
Fits a Honda Accord 2018 a bit tight but definitely fits. Added foam insulation to both sides so that could be also why it was so tight. Be careful taking it on or off since the plastic is very brittle and will snap when you least expect it to. For me the one of the clips that go into the door snapped off and fell inside the door and had me fishing for plastic inside the door lol
M**T
Perfect Asset for installing Honda Civic Speakers
Needed to replace my 2007 Honda Civic Speakers and they have these hook and single bolt construction designs in both the door and the back seats. I didn’t want to have to deal with the challenge of possibly drilling holes when seating new speakers so I went with these. They just worked great.I used some JVC 6” speakers, took the grills off, and then attached them to these supports. One hole aligned cleanly, the others (2 locations) I pre drilled a hole to attach the speaker to the tabs and then screwed them down solid. They were secure and ready to mount. Took the panel off my door, removed the old speakers, connected the new speakers, aligned the two tabs to slide the speaker in the door and reattached the primary securing screw. Was able to install both door speakers in less than 30 minutes and I’ve never worked with car audio before.If you want your install to get a little easier when replacing your speakers with ones that aren’t Honda branded and you have one of these Civic models, this will definitely save you time and make the install a lot easier and more secure without having to modify the door hardware. Recommended!!!
Trustpilot
4 days ago
2 months ago