RAHISH TOOLSRAHISH TOOLS 3 Piece T Handle Tap Wrench Set with Jaw Opening 1/16"-5/32", 5/32"-1/4", 1/4"-1/2" - Precise Tightening Wrenches Jaws Grip for Taps, Reamers, Screw Extractors, Drills - Made in India

This product is a fantastic find! It's reasonably priced, making it accessible for most budgets without compromising on quality. The product is exactly as described, and its usefulness cannot be overstated. I've found it to be incredibly practical and efficient in meeting my needs. The attention to detail is impressive, and the performance is on par with more expensive alternatives. If you're looking for something reliable, well-made, and at a fair price point, this is the perfect choice. Highly recommended!

As a former journeyman machinist, I can compare these to high-end tap wrenches like Starret. For the cost, these work fine but I did a modification to make these better. The steel is somewhat hardened at the jaws, albeit not the hardness you see in professional grade taps. The threads are a little rough, so put some heavy oil or grease on them and over time they will smooth out. I felt that the torque needed to tighten the jaws onto the tap was more than I liked, so I used a dremel tool and increased the length of the slots, which helps. The handle is comfortable, and the shaft has a spring load on it, providing a detent to hold the handle in place, that's a nice touch. You can also add some grip tape on the knurled cap to increase the diameter and make tightening easier. But overall is a good set and the value is hard to beat.

Some don't tighten down enough

Well these are inexpensive and you get what you pay for. The Good is there are three sizes for the price and they do hold taps which is what they are intended for. The Bad is the machining is poor becasue they probably crank out untold thousands of these per day, but the poor workmanship makes for very difficult tightening especially when you need to close them to the smallest diameter. The poor machining makes it very difficult to untighten. There are a lot of metal spurs and rough surfaces due to the cheap price.The chuck is poorly designed in that there are two "rings" of knurling which you must have to grip them. But the rings of knurling are indented so it makes them practically useless for gripping. The knurling needs to cover the entire surface of the chuck - not just two rings indented.The Ugly? It took me about an hour of my own time to work the metal and finishing such that they would work as well as possible. Buyer beware ...

Came promptly and in excellent condition.

Great tools. Made tapping holes a lot easier.

Part defective , design bad, or description wrong. On arrival it would not grab anything as tines bent outward. After a little bending it could be made to work but still the smallest T handle will not grab 1/16 inch parts (1.57mm) as description claims. Smallest it will grab is around 7/64ths. Smallest one is totally useless. The two larger ones work but the screw action is very rough.

Work pretty good