CornerFlex EasyCaulk Marine & RV (Light Brown)

Totally What I wanted for my RV Shower ! I'd consider it more of a finished look than ordinary caulk look however. Face it we all hate the Caulk Look!. When you are done you see no Caulk Look! All you see is nice smooth vinyl smooth surface. NICE. No ripples, no bumps, nice and smooth. It comes off the roll in the proper way also, no reason to lay it out I found. Go 2"-3" at a time. Just push it STRAIGHt in a corner, lightly 1st pass with finger or two till it is on and set. Then go back and push with THUMB moderately. On the back what seems like caulk, but a little better, is white and is on both sides of the triangle. It is pretty much 60/40 spread between one side and the other so equal adhesion per side of back triangle. I'd would not mess around pulling off 6' at a time, the caulk might fall off the back. No need to, this stuff is very pliable. 70Fwhen I worked with it. I cleaned area with Acetone and a Scotch pad-Green. Get all silicone off. Wipe with acetone till you see nothing on paper towel. Acetone seems to make the silicone roll up somehow. Use a few coats of light acetone then scrub it for best results. My shower looks great now and it looked like do-do before and it cost me $30.

Since it is coiled around in a circle, I'd recommend rolling it out and placing something on it to straighten it out before trying to install it. It kept curling up and wouldn't stay in place. The adhesive isn't very strong. Once we did this, now it stays in place and works great to seal out any water that might get in the way.

An easy to apply, good looking alternative to fooling with a caulk gun for sealing small seams. Not sure how it will stand under heavy conditions but works well in light rain and wetting.

The main issue is that it does not stick well. Looks great and has a nice finished look to it when it is staying in place as intended.

Great product, meet expectations. It perfectly seals my kitchen marble cover joints.

Great product...matched perfectly....curled up after Installation but a little heat applied with a heat gun solved the problem.

Works great. Tip: Heat up chalk and surface with a hair dryer fits and it sticks like crazy.

Worked great on the bottom of the bathtub where the bathtub meets the floor. It gives my floor a finished look.