An inexpensive utility gauge for the broad commercial and industrial markets. Suitable for air, water, oil, gas or any other media not corrosive to brass.
B**R
Bang On for your buck
Love the fact that these are the same mid grade gauge that would cost you 4-5X locally yet I had it the next morning and got a great price on a standard part. Hey, it seems like it's hard to find better quality.
C**P
Works
Gage works and doesn't leak. Rotating head only rotates 180 degrees and most times I wish it turned the other way. Automatic shut off is good. Button to release air works and needs a bit of force to operate but not too much.
A**R
So glad I bought this
For the regulator on my spray gun. I hope it lasts, it's great to have a guage that has the needed range for my spray gun using my diaphragm type regulator.
A**U
Accurate
Replacement for a Viair compressor
L**L
Great for displaying hobby air brush pressure
Low psi gauge isn't the most common, glad to find this product. The overall build is quite sturdy.Just a reminder that most pressure regulators on amazon comes with 1/8 BSP gauge port and is not compatible with 1/8 NPT. You will need an adaptor.
L**B
For the price it's ok, but...
So all things are relative... for the price I paid it worked well, some might give a negative review because they had higher expectations. Here's the deal, it works fine but just don't leave it under vacuum for a week, mine eventually... suddenly... read an even lower vacuum reading, as in more vacuum than outer space... instead of -30 it reads more like it is -35... I'm still able to use it to see there is no vacuum leak, just not an accurate reading anymore. Normally a gauge should operate under sustained pressures/vacuums shown on the scale, I did not exceed what was on the scale.I'd still buy it, but I got this one in addition to a more expensive one that I didn't want to use for the test rig. It might be more suitable for uses where temporary vacuum is applied and then released.
Z**H
They work when the ship you the correct item
I have 2 of these gauges installed on my 100psi air compressor and so far they both read within 3psi of each other (when the regulator is set to tank pressure).When they were shipped, one of them was the wrong gauge (15psi), in the correct box (160psi) which caused unnecessary hassle and downtime.
D**N
Does the job.
I used this gauge for my e61 brew head on my Profitec espresso machine. It's not the most accurate because it only reads pressures past ~2 bar, but it gives a good idea of where your brew pressure is at. I could get a more accurate gauge but aesthetically it would be too big for my machine. So, I wouldn't recommend this gauge if you plan on reading values for pre-infusion. For the price, I am happy with my purchase.
