High Temperature Thin Transparent Silicone Rubber Sheet with Adhesive, 60 A Durometer, 0.04" Thickness, 6.3" Width, 11.8" Length

For most people this material might be thicker than they would like apply to, say, their cell phone as an anti-slip aid. If it were available in a thinner version, it might be even better for such an application. However, it is very flexible with very good adhesion, so for me, it is much better than other products I have tried that were sold as "grip" or "anti-slip" material. I have not tried to remove the adhesive after application.

These sheets allow me to cut my own sizes and shapes. So far, I've used it on glasses, cabinet doors, and tray that kept sliding. The adhesion is great.

Great item .place it on my paddleball paddle. It gives me a solid hit when playing

I used this sheet to cut a new canister gasket seal. It stick really well can't adjust placement once its down. I was aware it was thin for the application I needed. It's easy to tear can't stretch the product without tearing it. But it works to keep my canister airtight once again.

I purchased this to cut custom pieces of non-stick feet out of and it hasnt disappointed. Cut 2 long strips to use as rubber feet for my keyboard, and it really doesnt budge. When I lift it it almost sticks to my table.

Really impressed with the adhesive here. This is a must have backer for adding grip to mechanisms. It gets dusty quickly but if you clean it off with an alcohol wipe it is instantly sticky again. Good addition to your FIRST competitive robotics supplies

One star off for being a little thicker than stated (about 1.3 mm thick and won't compress to 1mm). Otherwise, it work great on my custom keyboard as a DIY sound deadener between PCB and plate.

I've been using this stuff to add non-slip feet to craft projects. I found it relatively easy to make circular feet using a single-hole paper punch.

Clear and great adhesion.

Amazing amazing stuff for grip.