MPD DigitalI LMR400 Times Microwave Coaxial Cable I N Male to SMA Male Connectors I Low Loss RF Coaxial Cable I CB, Ham Radio, Transmitters, Antenna I 1ft

Retired EE. I got a pair of these for a MIMO antenna, and found that one was consistently loosing one bar of signal strength or more. I put in an old LMR 200 cable and all was well. One N male end was loose- inproper crimps on both the crimp sleeve and NO crimp on the pin, slipped right off. I found a similar no crimp pin on one SMA end also. I was able to easily pull it apart and reassemble, solder the pin and replace the crimp ring with a new one.I sure won't be buying cables premade from this alleged US assembler- they have serious training/QC problem.They don't seem to understand that SMA and N crimp connectors don't have a collet to tighten the male pin on the center wire like the clamp style do.

Excellent quality. Item is a little stiff and may cause problems if you need to make tight bends, but I should have expected that due to it being LMR-400, but with a little bit of re-designing in my project, it worked perfect. The coax is marked as Times Microwave, so it's the good stuff, not the cheap knock off. The connections feel tight and solid. I am using this inside a 12"x12"x4" NEMA4 box connecting a 1090MHZ filter to a bulkhead mounted polyphaser for an ADS-B set up on my tower.

Wow, awesome cable! Of course LMR400 is great cable, but I was really impressed with the high quality job done on the connectors. Awesome job complete with heat shrink tubing to seal them up. I'll definitely be ordering from them again in the future. Plus they offer just about any cable you can imagine and I'm sure they'd custom make anything you could dream up.

This looks like top quality cable that is made in the USA.Excellent for permanent outdoor installations that you want to avoid maintenance on. The cable is stiff and does not flex easily, but will flex with effort. Connector ends are well reinforced. Remember to water proof your outdoor connection.

i bought two of these 75 ft cable for my dual 24 dbi parabolic antenna set up, i don't have a single problem or complaint, the cables are very high quality i can send and received and strong signal from miles away, i have a high power router and a pair of originals sunhans boosters connect it to my two 24 dbi antennas using these cables and i don't have any big loss in dbi, and this is a 75 ft cable, you will have more loss buying a cheap 1 ft or 3 ft cable than using this 75 ft lmr 400 cable, my cables are on the roof taking the extreme heat from Puerto Rico weather, taking heavy rain, none of my cable are damage or broken, i highly recommend this cable, 5 stars is my honest and personal opinion.

Looked like a good cable until the end fell off. I thought it might have been an oversight with the crimp not being tight enough until a second cable did the same thing. Look elsewhere.

It is worth the money, if you want to use it on vhf, and uhf frequencies, such as I do. Little 'stiff'' to uncoil. I stretch it out, and leave it that way for a day or two, outside. Then run it through the 'pipe' I have in the roof to the 'ham-shack' several feet below.

Awesome, well built cable. Using for ADS-B receiver. Would and probably will buy again.

Excellent Quality cable.

Excellent quality and made in USA:)

It's a cable