HPSPerformance Stainless Steel T-Bolt Hose Clamp Size # 108, fit 4" ID hose SSTC-108-116 Polish 4.25"-4.57" (108mm-116mm)

Excellent clamp for replacing OEM one time use fittings. I bought this to replace the the one time use type of band clamp on my car that connects the air filter intake. The OEM part was fine, but once it is crimped into position at the factory, when you have to replace an air filter, you have to break the band. So this was the replacement and it can be used over and over again. Very well made.

These have been on a 87mm throttle body for about a week and so far no issues. Had to get them fairly tight to seal the coupler but they seem to be of good quality and I'm impressed.

fit great, and the nut seats against a round flange. this is important because alot of the ebay clamps or prepackaged universal intercooler kits have a hex shaped stop that the nut seats against and when using a ratcheting wrench to tighted it can slip off the nut onto the hex shaped stop and then lock the wrench inbetween teeth and then can't get the wrench off the nut nor switch the reversing lever on the wrench because it's bound between 2 teeth.This description of the common problem with cheap clamps might not make total sense to you, but once it happens to you once you will understand and want to throw away all the junk clamps that came in your ebay clamp/intercooler/pipe kit.

Worked great for attaching a Donaldson filter to a 4" polished aluminum pipe for my 7.3 intake

Okay, expensive for what they are, but well made and safer than using screw type of clamps as they spread the stress over a far larger area, rather than in one concentrated area. The "self locking nuts" seem to loose most of their self locking feature while tightening them down the first time. Unlikely that the self locking feature will be effective after the first use of these T-Clamps.These clamps also look far more cool that the screw type of clamps. They appear effective in holding Silicone hoses in place while under eighteen pounds of boost.

No matter which size you need, these are by far the best hose clamps in existence. Made of stainless steel with a nylon lock nut.I do wish the threads were longer, some of the hoses need a little more compression, thats only 1% of the time.

Quality product. Great service. The Capt.

Used this in the installation of my 6637 filter on my F250 7.3 and it worked great.

decent quality

Very good clamps. Stays tight compared to the worm drive type for my air intake

Seems great! Worked as it should!

Worked well for intended purpose

Works very well. Prices is good.