TaidacentStrain Gauge 350 Ohm Bend Flex Sensor Weighing Amplifier Module Pressure Sensor Analog Output Strain Gauge Test Kit (Extension Cable)

Works as expected on analog pins. Outputs are reasonably consistent (depends a lot on how you design the rest of the setup and interference from things like ceiling fans), but I found it's much easier to set triggers based on wide 100mV gaps rather than trying to get a precise numerical estimation of weight. It's also just fun to play around with.

The media could not be loaded. Feets are a bit short, even with the extended version. But I'm making it work for my project. Which is a proof of concept and this is a cheap and great device to prove that out.

Well, the module arrived but it was just the module. I know there is information here on the listing, but it would be nice to have a small card with specifications listed. This way, I know exactly what I’m looking at when I pull it for a project. Also, it would be nice if there was a PDF that characterizes the module in complete detail. Finding detailed documentation for cheap modules seems to be on par with finding a unicorn on the moon.

I found it hard to get consistent results with this flex sensor... it was hard to find where it was sensitive to bending. However, with a bit of experimenting, it should be an interesting sensor to couple to a microcontroller.

I plan on using the strain gauge module as a load cell to accurately determine the amount of filament remaining on the reel for my 3D printer. I'll glue the strain gauge to a flexible lever arm and activate the module when the filament reaches a certain level to reduce the required dynamic range. I should be able to get it accurate to a few grams of available filament left on the reel.I will input the strain gauge module's output to an HX711 Load Cell Amplifier A/D and connect that output to an Arduino to process.The strain gauge module has a Wheatstone bridge followed by an amplifier to bring the voltage to a 5V range.Note that there are many 350 ohm strain gauge sensors available on Amazon that are similar to that which this module uses for less than a dollar per unit so experimenting is inexpensive.

I'm using this as a feedback sensor and it's working out for me. since I didnt want to buildup a circuit to test what I was thinking, this saved me a lot of time and probably frustration. worked with a raspberry pi just fine as an analog input.

The media could not be loaded. The strain gauge is easy to set up and works as expected. Supply 5 volts, and you have it ready to go. I recorded a video of it working.

By default the potentiometer is set so that with the strain gauge unstressed the output is about 2.5V. Bending up or down by 30 degrees with change the voltage linearly to 5 and 0V respectively. I did not have a setup that would allow me to do controlled graphs of output vs amount of bend. I also did not look at the affects of temperature.One thing you can do is if you only need to know about flex in one direction you can adjust the pot to get get more range of motion in the direction you want to measure.Twisting the strain gage can affect you reading.If all you need is a touch sensor there are simpler solutions, but if you do need to know the relative amount of flex this may be a good solution for you.