CHANCS TYD-50 110V 5-6RPM CW 50/60Hz Electric Synchron Motor for Electric Fireplace

The media could not be loaded.  This little guy works well for my DIY rod dryer. I especially like that the shaft has an M4 threaded hole so I could mount my rod holder (that's actually the feature that made me choose this one). I wired it to a lamp cord with a switch on it, and by switching it on & off, I can reverse directions. The motor is a little loud in one direction, but its not a big deal. It runs smooth and consistent. I'd buy another when I need one.

Well, this didn't quite have the power I needed. It's pretty weak. If you only need a tiny bit of torque, this might do, but I had to go a bit bigger. Cheap enough to buy a few to experiment, might come in handy all sorts of ways, just know that it's not super strong...

After the drying motor died on my wrapping machine, I purchased this little jewel, and had it installed and running in 20 minutes. It worked as well as the old one, and at a very friendly price point.Shipping was not too bad from China either. About 10 days.I'm satisfied!

The motor shaft direction reverses every time I turn it on. This is not a problem for my project, but other users may want to know.

The 24 rpm motor worked well for my 3d printed watch winder. The gripe I have about the motor is that it vibrates at about 60 hertz which causes the watch winder to hum while in operation.

I purchased this motor to replace the 70+ year old motor in the Barber pole. The original motor was a bunch of copper wire windings and I looked everywhere for a replacement but apparently [they] stopped making them in 1987. So after a bunch of research, I figured this motor would turn the red/white/blue barber pole sleeve with a little help from a homemade shaft to screw into the motor shaft. Worked perfectly. The 30 RPM (I think) turns the sleeve just at the right speed.

This motor works great for a rotating sign that the motor had died. Only problem was I couldn’t get it in a D post so I had to modify the gear to fit. Otherwise it has been working perfectly.

I was able to install the motor with little problem and it worked great. I did need to splice additional wire into the leads, but other than that I am very pleased with the product.

Worked well to replace the broken motor in my electric fireplace, only complaint is it is a little noisy but more than tolerable.

Motor was seized when it arrived. Junk

Vraiment pas fort et change de sens de rotation pour rien et moteur devient très chaud

pour une flamme électrique poêle.

珈琲の自家焙煎用に購入。実は先に60rpmを買ったのであるが少々早いので約半数のこちらを追加購入した。希望する回転方向に回す回路図を同封してくれれば良かったのにと思う。現在のところ電源swを素早くON-OFF-ONして希望の方向に回している。